This adapter module allows you to control your Dexter Axle or Titan BrakeRite (T4813100, T4813102, T482250, or T4835700) electric-over-hydraulic brake actuator with your factory Ford, GMC, or Chevy brake controller.

This replacement inner member slide fits into existing outer member housings of your Dexter DX7.5L and Legacy UFP surge brake actuator. For use with tandem-axle trailers with hydraulic disc brakes.

Replaces shock absorber for Titan and Dico Model 60 brake actuators.

Replace the master cylinder on your Demco drum brake actuator. Fits all Demco drum brake actuators.

Replaces or adds an inline reverse lockout solenoid to Demco DA66B hydraulic trailer brake actuator. Non-bypass design allows you to thread the solenoid valve into your master cylinder for a hassle-free installation.

This replacement master cylinder fits Titan Aero 7500 trailer brake actuators for disc brakes.

Replacement assembly fits Titan Model 60 brake actuators.

Replaces the flat black plastic fill cap for your Titan 7,500-lb brake actuator (T4606520, T4500600, T4839100, T4839120, T4839300, or T4839400).

Replaces the inner slide assembly and coupler for your Model 10 Titan actuator.

Replacement fill cap fits your Dexter electric-over-hydraulic trailer brake actuator (K71-650 or K71-651). Fill cap with gasket forms a tight seal preventing leaks and fluid loss.

Replaces the 28" safety cable for your Demco hydraulic brake actuator (8605001, DM05692, or 8608611).

Replaces or adds an inline reverse lockout solenoid to Demco DA10, DA20, and DA91 hydraulic trailer brake actuators. Non-bypass design allows you to thread the solenoid valve into your master cylinder for a hassle-free installation.

Replaces the master cylinder for your Demco actuating brake coupler for disc brakes.

This shock acts as a direct replacement for the one that came with your Demco model DA10, DA16, DA20, or DA91 trailer brake actuator.

Replaces (1) 3/32" safety cable for Demco brake actuators.

This replacement 2-5/16" coupler slides into your Titan Model 10 trailer brake actuator. Primed finish.

Replaces the consumer lockout key for the brake lockout on your Dexter Axle brake actuator. Works with A-60, A-84, XR84, and new Titan Aero model actuators.

Install this manual reverse lockout so that you can back up your vehicle without triggering your trailer's brakes. Lockout installs on any Demco Model DA91 hydraulic brake actuator and is easily activated by hand. No wiring required.

Corrosion-resistant cover bolts onto the rear of your Titan Model 60 actuator to protect the electric reverse lockout valve.

Replaces the coupler pin on your Titan/UFP brake actuator with an over-center coupler latch (T4839100, T4500600, T4839120, and T4839000) so that you can secure the actuator to your hitch ball. Includes cable and snap ring.

Replaces the inner slide assembly for Titan Model 20 brake actuators with 2-5/16" drop couplers.