Chevrolet Colorado Brake Controller with Wiring

change vehicle

Select Chevrolet Colorado Year

--Select Year--201220112010200920082007200620052004

Available Years for Chevrolet Colorado Brake Controller with Wiring

2012

2011

2010

2009

2008

2007

2006

2005

2004

Trailer Brake Controllers

Proportional Brake Controller

Time Delay Brake Controller

Air to Electric Brake Control

Universal Brake Controller Wiring Kit

Wireless RF Brake Controller

Trailer and Brake Parts

Trailer Breakaway Kits

Trailer Brakes

Trailer Hubs and Drums

Trailer Tires and Wheels

Brake Actuator Couplers

Wire, Adapters and Trailer Harness

Brake Controller Manufacturers

Tekonsha Brake Controller

Hopkins Brake Controller

Draw-Tite Brake Controller

Hayes Brake Controller

Dexter Brake Controller

Chevrolet Colorado Brake Controller Questions and Answers

• Is the Tekonsha P2 Brake Controller Made in the USA
  
• Yes, the Tekonsha Prodigy P2 Brake Controller # 90885 in made the USA. I attached an installation video for his product for you to check out also.
  view full answer...


• Red Light Flashes on Primus IQ After Battery Was Replaced on a 2005 Chevrolet Colorado
  
• I spoke with my contact at Tekonsha about the issue that you are having with your Primus IQ brake controller. His recommendation was to reset the brake controller. To do this, you simply unplug the connector at the back of the brake controller for about 20 seconds and the reconnect the connector to the brake controller. He told me that this can happen to brake controllers when the vehicle batteries are replaced, especially if the brake controller is left connected in the vehicle while the ba
  view full answer...


• Which Brake Wire Is Needed for Brake Controller Installation on a 2010 Chevrolet Colorado
  
• I looked up the 2010 Chevrolet Colorado and the two switches on your brake pedal is for the brake light and the other switch is for the traction control/cruise control. You will need to use a circuit tester like the Quickee Tester, part # 3808, and test the wires. I would start by looking for a light blue wire and test that wire for power only when the brakes are applied. I am including a link to a FAQ page on brake controllers. It does list some colors of the wires on vehicles that are need
  view full answer...


• Installation of Brake Controller on a 2008 Chevrolet Colorado Z71 With 4-Way Connector
  
• The 2008 Chevrolet Colorado will only have the wiring for a brake controller if your vehicle came with a factory 7-Way connector on the rear of your truck. To install a brake controller on your Colorado with a 4-Way you will need to hardwire the brake controller using the Brake Controller 7 & 4 Way Installation Kit, part # ETBC7. This kit will have a 7 and 4 Way connector that plugs into your existing 4-Way and all of the wiring and circuit breakers needed to install the connector at the rear
  view full answer...


• Connecting the Red Wire from a Brake Controller to a 2006 Chevy Colorado
  
• The red wire from the brake controller needs to be connected to the wire that becomes hot when the brake pedal is pressed. You will need to use a tester or voltage meter on the wires and press the brake pedal to see which wire is the correct one.
  view full answer...