Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
With having 22'6" from your tail light location to the tongue on your trailer I recommend going with at least a 30' wiring harness. The additional length is needed so you will be able to route your wiring on the frame to the lights and…
view full answer...The brake controller install harness on your 2022 Jeep Grand Cherokee 4xe is under the dash, to the left of the steering column, taped to another harness near the emergency brake pedal. The Tekonsha brake controllers like the Prodigy P3 part #90195…
view full answer...Hands down the easiest trailer brake controller to install in your 2022 Jeep Grand Cherokee with the tow package is the Curt Echo #C51180. This controller plugs into the 7-way connector on your Jeep, you pair it to your phone, and then plug your…
view full answer...One wheel locking up on your trailers brakes could be for a few reason. Most likely it's due to a brake assembly that is out of adjustment. You want to adjust the assemblies so there is only a light drag on them when they are turned by hand.…
view full answer...I will start by sating that the wheels/tires on the trailer you are looking at do look kind of undersized. So you definitely can stay with a 13" set up like the Kenda Karrier ST185/80R13 Radial Trailer Tire - Load Range D #AM10208 and Dexstar…
view full answer...Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…
view full answer...Locking out a Titan Model 60 actuator like the part #T63FR that you referenced requires inserting the lock out tool into the into the slot right behind the portion of the coupler that inserts into the outer casing. I pointed out where in the attached…
view full answer...Locking out a Titan Model 60 actuator like the part #T63FR that you referenced requires inserting the lock out tool into the into the slot right behind the portion of the coupler that inserts into the outer casing. I pointed out where in the attached…
view full answer...It's not common for the spindle number to be printed anywhere on the axle. That said, if you're looking for new bearings/races and seals all you need to do is note the capacity or measure. The easiest method would be to crawl under the…
view full answer...When we installed the Draw-Tite Sportframe Trailer Hitch Receiver #24872 on a 2014 Ford Focus Hatchback in our shop we found the receiver height to be 10-3/4" from the ground. The Draw-Tite Drawbar #3593 gives you a 2-1/8" rise so that…
view full answer...For a 9/16 inch shackle bolt such as #TRFA73Z916DLNZ you will want 65 to 95 foot pounds of torque. Provided that you are within that range you won't over-torque the nuts. A little bit of play is expected but large gaps could be taken up using…
view full answer...The correct trailer idler hub for your boat trailer is the Trailer Idler Hub Assembly for 3,500-lb Axles part #AKIHUB-545-35-K or part #AKIHUB-545-35-EZ-K if you have zerk fittings on the spindle. These are both pre-greased so there is no mess to be…
view full answer...Related Searches
Filter Your Search
Contact and Help