View Cart

Dodge Sprinter Brake Controller

Select Vehicle Year

  
Brake Controller

Available Years for Dodge Sprinter Brake Controller


Brake Controller

Brake controllers are an essential part of a towing system with electric trailer brakes, and they offer a much-needed emergency braking feature. We offer high quality controllers from manufacturers such as Draw-Tite, Tekonsha, Valley, Hidden Hitch and Hopkins. Featuring both time-delay and proportional models, we have the right controller for any application. Brake controller wiring adapters are available for many vehicles, allowing for simple plug-and-play installation. Hardwire kits are also available to make any installation hassle-free.

Find your custom fit brake controller wiring adapter for a plug-in application by selecting the year of your vehicle to the left. We offer custom fit plug in adapters for many of the most popular vehicles, including Ford, Chevrolet, Dodge, GMC, Nissan, and Toyota.





Brake Controller Manufacturers


Search For Custom Fit Dodge Sprinter Accessories
Select A Category Below



Dodge Sprinter Brake Controller Videos

Trailer Brake Controller Installation - 2006 Dodge Sprinter

Today on our 2006 Dodge Sprinter van, we'll be installing the TrailerMate X10 Trailer Brake Controller for the 1 to 4 axle in a proportional style, part number TM75813. To begin with, we will need to find a suitable location to mount the brake controller inside the vehicle on the driver's side. We first began by checking to make sure that there was nothing behind the dash that would be interfered with if we drilled through to mount the bracket. You want to make sure that you mount the brake controller in a convenient location but yet it's easily accessible to the driver while they are still driving. In this particular vehicle, there was not a good place on the right-hand side of the steering wheel to mount the brake controller, so we had to go ahead and mount it on the left-hand side on the lower dash. With that done, we'll go ahead and take the 4 screws and mount the actual brake controller to the bracket. A tech tip for this particular brake controller, the screen can be a little difficult to read.



Trailer Brake Controller Installation - 2008 Dodge Sprinter

Today on our 2008 Dodge Sprinter, we're going to be installing the Tekonsha P3 Trailer Brake Controller for 1 to 4 axles in the proportional design, part number 90195. On today's Dodge Sprinter, it's actually a motor home conversion, but it will be a similar installation. There may be some additional wiring in this particular model just because it's in a motor home conversion kit. We will be able to show you where the plug is and the installation will be very similar. To begin with, we're going to need to remove a few items just to make our installation a little easier. This vehicle does already have a trailer package prep kit on it, so it has a 7-way plug at the rear of the vehicle and the wires are actually routed up underneath the driver's seat.



Trailer Brake Controller Installation - 2004 Dodge Sprinter

Today on this 2004 Dodge Sprinter van, were going to install part number 39523, the Pod brake controller. Also to install this brake controller were going to use part number ETBC7, the installation kit. Well start off by installing our bracket and our seven pole wiring harness to the bracket. With our bracket installed well go and add the grey cable. Well split the sheath back a little bit and well have a white and black wires inside. Well connect those up to the wires from the seven pole.