Search: weld on tie down   >  

I pulled up the owners manual of your 2014 Ford F-150 and it looks like fuse number 67 is the trailer running light circuit so that would be the one you would need to check. It takes a 20 amp fuse.

You'll need to start by having a new hanger welded on since it looks like the hanger towards the front of the trailer has been broken off. Once that's welded in place you can then install a new leaf spring. To determine the correct…

The trailer wheel part #AM32575 that you referenced is designed to be used with acorn lug nuts and not ball style. The part #KALN1375S would work great as this is the correct size, taper, and since it's a solid stainless steel lug nut you…

When choosing between the Single-Axle Trailer Hanger Kit for Double-Eye Springs part #APS1, part #APS2, and part #APS3 it will be best to use the one that has measurements that most closely resemble what is already on your trailer. For example, if…

I attached the chart you referenced and it states that when you use a #e54SR spring with a hanger kit part #APS3 the hanger distance should be 24-7/8 inches. The length of a spring when new and not installed on a trailer will be slightly shorter than…

Bushings do not always have to be used. Springs typically have bushings or they will use wet bolts depending on which part of the suspension system it is but not always. The bushings limit the wear on the suspension components. There are just…

The APS1, APS2, and APS3 are all suspension kits for single-axle trailers with 1-3/4-inch double-eye springs. They are designed for use on trailers with single, 2,000-lb to 7,000-lb axles. The difference in the kits are in the rear hangers and the…

I went out to the warehouse and pulled hanger kit #APS1 to measure the hangers for you. The larger hangers measure 3 inches long, 2-5/16 inches wide, and 2-1/8 inches tall overall. The smaller hangers are 2-1/8 inches long, 1-13/16 inches wide, and…

The center bolt of a leaf spring such as #e54SR is essentially structural integrity. The bolt goes through the leafs and helps ensure stability. If you take a look at the photo I've added you can see how the U-bolts and center bolt of the leaf…

Thank you for all of the info! I'd be more than happy to help out. For an axle that meets your specs I recommend going with our etrailer Trailer Axle #e37YR which has the 58" spring-center measurement, a 72" hub-face measurement, has an…

I'd be more than happy to help you out! If you can measure the hub-face and spring-center measurements of your current axle that will help me know what you're needing. For example, the etrailer Trailer Axle with Idler Hubs #e65GR has a…

The Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel part #AM32238B has a bolt pattern of 5 on 4.5". Check out the link I've added to see how to measure the current hubs and see if they're a match. If that…