Search: safety cable > Safety Cables >
Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I do have several replacement parts available for the RAM Trailer Jack part #TJD-7000S but not an all inclusive rebuild kit. Instead you will need to select from the components listed below and repair the jack as needed. The most common fault on the…
view full answer...Left and Right side on a trailer is noted as if you were sitting in your vehicle. Left would be driver side and right would be passenger side. In the case of your Wesbar 003372 light that you mentioned, these can actually be oriented 2 different ways…
view full answer...For your Optronics light part as2t216 we have found that the correct replacement lens is the part #AST60B.
view full answer...The Sleeve-Lock A-Frame Trailer Coupler - Flip Latch - Black - 2-5/16" Ball - 12,500 lbs #CA-5296-B you were looking at is designed to be welded on and as you noticed, does not have the bolt holes available. Instead I recommend going with the…
view full answer...To get the Dexter Zinc-Plated, Leverlock Coupler #T4845000 in a higher weight rating you'll need to bump up to a hydraulic actuator like what we see with part #DX89FR which has a 7.5K weight rating. For an alternative standard coupler solution I…
view full answer...You will need to choose a jack whose capacity exceeds the fully loaded and ready to tow tongue weight of your trailer. Typically trailer tongue weight is 10-15 percent of the weight of the trailer. This means that when loaded to maximum, your tongue…
view full answer...Hey Savannah, yes the Ram Jack Repair kit part #TJD-7000S-HDKT is correct for the Square Direct Weld Jack #TJD-8000S that you mentioned. I attached an install video for the repair kit too if you wanted a guide for the whole install process as well.
view full answer...Hey Christopher, so all of the WD systems that have friction sway control will require drilling into the trailer frame for at least just the sway control as that's how it attaches to side of trailer frame but I do have a similar solution that I…
view full answer...The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…
view full answer...While we no longer carry the Lionshead Wildcat we do have the Castle Rock ST225/75R15 Radial Tire w/ 15" Liger Aluminum Wheel #LH29FR. If your trailer did not include a spare you could order 2 new wheels and tires so they match and use your good…
view full answer...I took a look at the A-60 Surge Brake Actuator like the Dexter #DX56FR, and to remove the front pin you'll need to remove the locking ring from the front rolling pin on the passenger side, and push it out from the passenger side to the driver…
view full answer...We have an option for you, though there isn't a way to get matching keys for a Master Lock #2848DAT trailer hitch and coupler lock set as they don't have a Keyed Alike option for a second set. What you can do in order to use the same key for…
view full answer...Filters
- 27 results
Vehicle Fit
Related Searches
Filters
