Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Hugh! Both the 5" #YR530R-5P and 4-3/8" #YR343R-5P Yates Ribbed Wobble Roller will work with the CE Smith Universal-Fit Split Panel Brackets for Boat Trailers #CE10500G. These are designed around a 5/8" shaft and the brackets fit…
view full answer...Hey Robert, we don't have any roller wheels that have large enough U-bolts to fit around 3 inch hitch tubing so best option would be a weld on roller like the Ultra Fab part #UF48-979023. Are you dragging on your driveway?
view full answer...Hey Dave, it's great to hear from you again! The CE Smith U-Bolt - Zinc-Plated Steel - 3" Long x 3-1/8" Wide x 7/16" Diameter #CE15252A you were looking at could work for if the dimensions match what you currently have. You…
view full answer...Hello Trent, thanks for reaching out. Does your RV happen to have a tow-rated bumper? If so, a great option for carrying/securing your generator is the 24x60 etrailer Enclosed Cargo Carrier for RV Bumper #e34VV. This attaches to a 4" or…
view full answer...You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…
view full answer...There isn't a gauge requirement for the thermostat wiring of the Furrion Chill RV AC units like the part #FR92PR but it's not a circuit that carries a lot of amperage so a 14-gauge wire would work well.
view full answer...The Yakima HoldUp you referenced isn't a good choice for bike with fenders. The ratcheting hooks can't be tightened enough to get a good hold on the front bike wheels. For bikes with fenders a better choice would be one of the following bike…
view full answer...For starters, if your 2013 GMC Savana 2500 came with a factor 7-way trailer connector the the four wires you will need to install a brake controller like the Tekonsha Primus IQ Trailer Brake Controller part #TK90160 are already ran for you under the…
view full answer...Hey Mark, thanks for the information. The highest capacity roller bunks we have are the 3,000 lbs Boat Trailer Standard Roller Bunks item #DL21755. The Tie Down Roller Bunks for Boat Trailers item #TD87FR, you were looking at, top out at 1,500 lbs.…
view full answer...The roller part #MAL52VR is 2 inch in diameter and has a 375 lb capacity when used in the upright carrier part #MAL32VR.
view full answer...I attached a wiring diagram for the Solera Power Awning Switch Kit #LC285500 for you to check out.
view full answer...Yes we do, the correct oil seal you would need is the part #10-56 which I verified has same dimensions as the 295924 that you have now.
view full answer...