In-Depth Review of the Optronics LED Trailer Tail Light Video

Hey Greg, thanks for reaching out to us! Hopefully I can help you get all of this figured out so you can seamlessly keep your refrigerator battery charged up. It sounds like you're needing the Redarc In-Vehicle BCDC Trailer Battery Charger…

Yes, you can replace your load range C tires with load range D tires without issue. It will only become any issue when you go down load ranges, not up. The tires will have the same overall diameter as long as they are the same size regardless of…

The Redarc BCDC Charger part #RED36TR can work with your fridge but it wasn't designed to power accessories directly. You could use it to charge your 12 volt battery that is then powering your 3-way fridge on DC mode though.

The Fulton Single Axle Trailer Fender with Top Step #F008554 is designed to fit tire on a 14 inch wheel. The dimensions are: 9.7" wide x 31.3" long x 12.75" tall. The top step is 8 inches wide and it has a capacity of 300 lbs. You can…

Typically trailer lights don't end up on fenders, but since your plan is to use this fender #F008564 on a tow dolly I could see how that would be required. On the ends of the fender where the plastic goes vertical you could mount the Sealed,…

Axles that are 3,500 lbs are all 2-3/8 inches in diameter, and that is the diameter of the 3,500 lb Dexter Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 89" Long - 3,500 lbs #35545I-ST-89.

The model 1980 Bearing Buddy simply means that they fit a 1.980 inch hub bore. There is one difference of note between Bearing Buddy Bearing Protectors #BB1980A (Chrome Plated) or #BB1980A-SS (Stainless Steel) and the Bearing Buddy Bearing Protectors…

For the clearance light part #AL91RB we have the grommet part #A91GB which is basically a hard rubber.

Based on what information I could find about AL-KO 8490 hub and drums, it is rated for 3,500 pound axles, has a 5 on 4-1/2 bolt pattern, and is a 10 by 2-1/4 inch drum. If this is the case, we have several options for you. I have attached a link to…

We do carry a range of replacement trailer brake magnets and you can use the link provided at right. The best and easiest way to find replacement bearings and seals is to obtain the part numbers from the original parts. My research on your Al-Ko hub…

Based on what we could find, the AL-KO 8490 is a 3,500 lb axle, and your info stating the 5 on 4-1/2" bolt pattern and 10" x 2-1/4" drum size supports that as well. I do recommend verifying what you need by taking apart your current…

I'm not sure what process you used to clean and lubricate your #RM-522, but I would soak the arms with degreaser and then move the arms in and out while rinsing them off with water. You can also use the Roadmaster Tow Bar Cleaner #RM-9932. After…