Hey Patrick, thanks for reaching out. Based on your description, it sounds like your Ahara has two separate analog thermostats, with each one controlling its own A/C unit. In that case, the Coleman-Mach WiFi Thermostat #CM46MR is not designed to…
Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…
Hey Alan, welcome back! The Velit Diesel RV Heater for Camper Van #VE66QV is capable of heating a trailer that size. However, a major factor in how effective it is will be the insulation on the trailer. Even with adequate installation it may be…
Hello Gregg, I think I can help shed some light on what is going on. Basically, there are two ways to stop surge brakes from actuating when backing up the trailer. The first and most popular way to do this is to use a surge brake actuator with a…
Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…
Hey Tim, you could use the Equal-I-Zer shank part #EQ90-02-4800 in place of the Blue Ox Shank part #BXW4028. This will weigh less and not hang down nearly as much. How do you like your Blue Ox setup?
Yes, you can swap out a 2" weight distribution shank for a 2-1/2" weight distribution shank. This will actually be the preferred method instead of using a sleeve adapter as there will be much less movement inside the receiver tube. I…
The number you have provided sounds like a Bargman 84 series light. The lens you need is #34-85-750. If you roll your mouse over the picture to zoom in, you will see that same SAE AR 84 DOT number on the lens.
Hey Bill, thanks for reaching out. I just went out to our warehouse and measured the Replacement Left/Curb Side Leg for etrailer and Ram Hydraulic Jack #e63VV. The outer tube is 4-1/2" square. The inner tube with the foot is 4".
Hey Bryan, Dometic has the CT Thermostat and Control Board part #DMC83ZR as a fit for all single zone Dometic units so yes it would work well on your Duo Therm.
The Lippert Replacement End Fitting for Hydraulic Hose on RV Leveling Systems - ORFS #LC249363 uses an ORFS or O-ring face seal fitting. The 1/4" female port does not use an O-ring so there is no size available. The O-ring will depend on the…
Filters
