Search: ball mount lock   >  

There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a…

For your 2019 Nissan Titan I recommend the Curt hitch part #C13304 as it has the highest weight capacities and has the shortest install listed as well. I attached an install video and picture for you to check out as well.

The Westin grille guards may look the same, but if this grille guard did not come from a 2007 Dodge Ram Pickup, it will not fit. The dimensions of your grille guard must be the same in order for the mounting brackets and the hardware to fit.…

In the 4-on-4 wheel bolt pattern we offer trailer wheels/tires from 8-inch up to 14-inch diameter, but no 15s. The available products in this bolt pattern are shown on the linked page. The highest weight capacity wheel/tire in this 4-on-4 pattern…

Ways to raise the height of a trailer for better ground clearance include using larger wheels/tires and installing an axle over-under kit that reverses the placement of the springs and axle. An axle over-under kit (we offer two) will give you a…

Since the only difference between the SumoSprings Solo Custom Helper Springs #SS76MR and #SS86MR is the weight rating (the former being 1,000 lbs and the latter being 1,500 lbs) I recommend going with the lighter option - part #SS76MR. It would be…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The cable loop for the breakaway switch in the Trailer Break Away Kit With Built-In Tester and Battery Charger, #50-85-315, does not attach to the ball. Run the pin through a safety chain loop on the hitch. Pass it through the loop on the other end…

Thank you for your purchase of the Demco Channel Tongue Trailer Coupler - eZ-Latch. The diameter is 5/16" and the lock that is designed specifically for Demco couplers with the eZ-Latch is the following: - InfiniteRule Lock for Demco eZ-Latch…

I really wish we had a coupler lock in the dimensions you listed, but the closest thing we offer is the part #e98888 that you referenced that has a 1/4 inch diameter pin that is 3-3/8 inches long. The difference would only be 1/16 of an inch so this…

If your Explorer has the OEM 1-1/4 x 1-1/4 hitch, the lock will NOT work. If you have the 1-1/4 inch receiver, you would need a lock with a 1/2 inch diameter pin, like the etrailer Lock #e98880. The Master Lock Stainless Steel Trailer Lock you asked…

The Blaylock EZ Lock Trailer Coupler Lock part #BLTL-33-40D is only for use when the trailer is not connected to the tow vehicle. If you are looking for a locking device that will work while coupled you can just use a standard pin lock like the…