Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…
Jason, you only need one Hub Saver per wheel. Since they're sold in a pack of two, one package is enough for a single-axle trailer with two hubs. If you have a tandem-axle trailer, you'll need two packs to cover all four wheels. The Hub Saver…
I took a look at the wheel lug stud LCI SKU 121803 you mentioned, and I was able to find the Kodiak Wheel Bolt #K12WB2. This bolt is 2" long, and has a thread size of 1/2"-20 UNF-2A.
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Hey John, the replacement gear kit you'd need is the part #TJD-12000-RODNUT which I attached two pictures that have instructions and an install diagram.
The Kodiak kit part #K2R1058D11DAC does fit your Dexter 10k axle made in 2008 as this fits Dexter or Lippert 10k axles made prior to 2009. This attaches to the hubs you have already. When it's time to pick out an electric over hydraulic actuator…
Hello Baltazar. I am happy to look into it and recommend parts for you, but I will need more information from you first. Mainly I need to know what kind of brakes are currently on your trailer. If you have electric brakes you are going to need a full…
The disc brake kits like #K2R1058D13 are designed for torsion axles and disc brake rated EOH systems which have a higher 1600 psi level than drum brake actuators. This is currently the only kit we have compatible with 10K torsion axles from Lippert…
Thanks for getting me all the info needed to pick out a hub! Based on what you listed the correct hub you need for a replacement is the part #84545BX. This uses the same bearings as what you have and has a matching bolt pattern.
Backspacing and offset are terms used to look at the same thing in a different way. Backspacing is described as the distance from the center of the hub to the inside edge of the wheel at the bead seat whereas offset is the distance from the center of…
A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…
Yes, the correct replacement right rear leg for the Ground Control 3.0 is the Replacement 24-1/2" Right Rear Leg - Lippert Ground Control 3.0 Electric Leveling System #LC344792. For whatever reason this leg doesn't come with the snapper pin…
Filters
