Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Aaron, for 15 inch trailer wheels the recommended torque value is 90-120 ft lbs for the lug nuts. This is true for the Lippert lug nuts part #LC63ZP that you referenced as well.
view full answer...There are centric rings you can find which will allow you to mount a Wheel #AM20790 having a 4.88" pilot diameter on a axle designed for 4.77" pilot holes. You will need to locate these centric rings as they are not something we currently…
view full answer...A keen observation indeed, Brett. The mounting hole spacing on the Square D-Ring Tie-Down Anchor #ABS69FR is 3" horizontally and 3-1/4" vertically. I edited a picture for you to help illustrate.
view full answer...Hey Mike, we have a similar hub that does fit a 12k Dexter dually hub with the part #8-214-8UC1. The 10k part #8-214-5 does have same bearings and seal so it would fit technically but it would not be weight rated for a 12k axle. For a drum you would…
view full answer...There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…
view full answer...The hub that you are looking for comes in the Trailer Hub Assembly #8-91-05UC1 on our site. For the E-Z Lube version you would instead want the Trailer Hub Assembly #8-91-05UC1-EZ. I contacted Dexter Axle and confirmed that these were the correct…
view full answer...According to my contact at Bulldog a replacement plunger pin assembly for their landing gear set #BD500170 is not offered as a separate replacement part. However we offer the Stromberg Carlson Pull Pins #LG-119113 that also have a 3/8-diameter pin.…
view full answer...I attached the chart you referenced and it states that when you use a #e54SR spring with a hanger kit part #APS3 the hanger distance should be 24-7/8 inches. The length of a spring when new and not installed on a trailer will be slightly shorter than…
view full answer...Hello Al, Happy to get those for you. I would want to take a gander at them too, just to see what I’m getting myself into. I was able to get the instructions for the Advent Air Low Profile RV Air Conditioner System, Single Zone, 15,000 Btu, White,…
view full answer...If you take a look at the provided photo, you can see the important dimensions of the #TRU37FR spindle.
view full answer...The Axletek 44-GG is a 10 inch by 2-1/4 inch 3,500 lb axle brake assembly which we offer with the part #AKEBRK-35L-SA.
view full answer...When finding replacement wheel studs you would have to measure them with a digital caliper like The 4 inch Carbon Fiber Digital Caliper #PTW80157. I will attach a diagram with the measurements needed to get the correct wheel studs you would need.…
view full answer...