Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…
view full answer...The MORyde Rubber Equalizer #MR87ZR could absolutely be used on an enclosed trailer. The 8K rating would be per axle. It might be more accurate to say that these equalizers can be used on axles 8K and under. So if your trailer is 10K gross weight,…
view full answer...To add a hitch to your 2024 Jeep Grand Cherokee L, I recommend the Draw-Tite item #DT42GR. This hitch is custom fit and bolts to your Jeep with included hardware. This is a class III hitch with a 2" receiver. It has a 7,500 lbs towing…
view full answer...You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…
view full answer...The Trailer Valet JXS Trailer Jack #TV34FR will come already lubricated. It is recommend to grease the internal gear system every 90 days.
view full answer...The mounting bracket for the #TV34FR is actually identical to the bracket on the #TV64FR that you were looking at. The holes are 1" apart on center vertically, and 5-1/2" apart horizontally. I have attached a picture for your reference.
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...To install the BAKFlip G2 Hard Tonneau Cover #BAK26525 on your 2021 Nissan Titan 5-1/2 Foot Bed with Utili-Track System you'll need to follow the steps listed below: 1. Slide the front half of the clamp into the rail in the tapered slot. Position…
view full answer...Thanks for the photo and good information! The Curt Spectrum Trailer Brake Controller #C51170 doesn't come with a universal pigtail but that can be acquired with part #C51515. Then all you need to do is match the following wires from the pigtail…
view full answer...I've attached the photos of the instructions that come with the Trailer Valet XL Mounting Bracket #TVXLMB. It's a 2 page document, but hopefully it gives you a good idea of how it mounts and works with a Trailer Valet #TVXL2 or #TVXL25.
view full answer...The Optronics Flexible LED Light Strip #UCL90CB that you referenced does put off a bit off a purplish hue. If you check out the two pictures I attached you'll see what I mean. It still puts out enough light to be useful though so it would work…
view full answer...You are right on everything you have said. The manual dollies like #RA20 do not have the capacity for your 8,000 pound trailer. There is a manual crank type, #STC-V211, but its tongue weight capacity is 500 pounds. The motorized ones that you…
view full answer...Related Searches
Filter Your Search