The most common bearings and seals for a 7,000 pound axle are #25580 inner bearing, #14125A outer bearing, #25520 inner race and #14276 outer race. The grease seal can vary, and will usually either be the #GS-2250DL, which has a 2.250 inch inner…
The backing plate you are referring to is, I'm assuming, the brake mounting flange, which should be welded on. The dimensions of this are extremely important because it will determine the brake assemblies that fit. The Demco Trailer Brake…
I spoke with my contact at Americana and they told me that the Americana Trailer Wheel Center Cap, part #AM90091, will fit all 15 inch wheels regardless of the lug bolts, as long as the pilot hole is 3.19 inches diameter.
Backspacing and offset are terms used to look at the same thing in a different way. Backspacing is described as the distance from the center of the hub to the inside edge of the wheel at the bead seat whereas offset is the distance from the center of…
The #42 E-Z Lube Spindle w/ Flange #TRU37FR has a 1"-14 thread size. A replacement Trailer Spindle Nut #165686 is available if the treads are damaged on the castle nut.
Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…
There really should be a flat washer between the outer bearing of your hub and the nut that holds it on. The washer protects the back side of the bearing from the edges and points on the back side of the spindle nut. The Washer For 1 inch Spindle,…
For a great option of Nev-R-Adjust brakes on your 1999 Jayco Designed 5th-wheel trailer, I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Assembly - 12" - Right Hand #23-459 along with the Dexter Nev-R-Adjust Electric Trailer Brake…
Hey Ted, you can do it a couple ways. Easiest being to find the label on the axle that has the capacity and verify that you have a 3,500 lb axle. If so, this kit part #TMK52VR would be correct. Otherwise you can measure diameter of the axle as a…
Triple-lip grease seals have been around for a while, and you're not going to notice a benefit with them over the double-lipped Grease Seals #RG06-050. We do not have triple lip seals, and they're honestly just not necessary.
The short answer is Yes, bearing #15123 is slightly larger and stronger than #LM67048 and they use different races which means they are not interchangeable. Bearing 15123 uses race #15245 which has an outer diameter of 2.441 inches and bearing…
Hey Greg, The #AKIHUB-545-2-EZ-2K uses bearing #L44649 for both the inner and outer bearings and #10-9 for the grease seal so you could just swap to the #AKIHUB-545-2-LFEZ-2K instead since it fits 13" - 15" wheels. That being said, I've…
Filters
