Result: 02475

Hey Michael, the Timbren Axle Less systems like the part #T43AV which is a 5.2k axle setup would be your best solution. These are just a lot tougher than standard trailer suspension which just wasn't designed for off-road whereas the Timbrens…

You will want to look at the legs of your steps to determine which MORryde steps you have. If your MORryde steps have a pull pin then you've got the 1st generation. If you have a button that releases the legs for adjustment, you have the second…

The four bolt brake mounting flange for 8,000 lb trailer axles is going to be more or less an industry standard. This industry standard is 3-5/8" across left to right on center and 3-7/16" top to bottom on center. This could very well vary…

Hey Jay, yes the wet bolts for the suspension hangers are included with the MORryde X-Factor part #MR33WR that you referenced. In the attached picture you can see the new looking silver wet bolt holding the CRE3000 equalizer.

The Replacement Wet Shoulder Bolt #LC126238 is exactly what you are looking for. It's the correct length and diameter as well as has the zerk fitting needed to grease it.

I would be happy to help you! The EZ loader oil bath hub assembly 300-029534 is a complete 5-on-4-1/2 idler hub kit that includes races, bearings, seal, washers, nut, retainer nut and cotter pin, bearing protector and lug nuts. Some of these hubs fit…

For trailer tail lights you need to measure the overall width of your Karavan 6'x12' single axle trailer. So you will need to measure to the widest part of the fenders which appears it will be roughly 96" wide. Based on images I could…

The manufacturer of a trailer can sometimes confirm specific parts using the trailer's VIN but the best way to know what replacement bearings and seals you need is to pull one of the hubs and to remove those parts. Then it is usually easy to find…

The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel trailer…

Hey Michael, the install of the etrailer base plate kit part #e96GV does require moving the adaptive cruise control bracket in most situations. That is still true so it would be likely you'd need to move yours on a 25 Maverick Lariat.

The Draw-Tite 41954 Class V hitch which we offer as part #DT35MR is designed for 2015 - 2022 Ford F-150 models that aren't equipped with a factory hitch. I've made up a diagram showing the dimensions and hole spacing for you.

I do have several replacement parts available for the RAM Trailer Jack part #TJD-7000S but not an all inclusive rebuild kit. Instead you will need to select from the components listed below and repair the jack as needed. The most common fault on the…