Result: 15245

The Kodiak Disc Brake Kit #K2HR10A11RERR is actually specifically designed to fit an AL-KO 10k #99 spindle, so this will be a perfect replacement. Though this does include the oil cap, it should be noted that it does not include the bearings or seal.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

For a 10k AL-KO trailer axle we have the Kodiak Disc Brake Kit part #K2HR10A11RERR but the #K2HR12A11-120DW that you referenced is designed for a 12k AL-KO axle.

The mounting plate on the ARK Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR is 5-1/2" wide and 7-1/2" tall. It is designed with several bolt hole patterns(see image) to fit trailer tongues from 2-6" tall.

The weld-on mounting bracket for the ARK #AR94FR Drop Down Corner RV Stabilizer Jacks measures 4-5/8 x 2-7/8 inches. The bracket has holes for the hardware that attaches the jack to the brackets. The holes are 2-7/8 inches apart on center. I've…

I had the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR measured and the distance from the center of the crank bolt to the top of the mounting flange is 2-1/2".

I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need…

The best replacement option we offer for a Atwood GC10A-4E Water Heater is tankless, the Furrion RV Tankless Water Heater part #FR68SR. It won't be a direct replacement but still pretty easy nonetheless as they are very similar. That said, you…

The replacement inner lift tube BD84FR has recently gone inactive and is no longer available from Bulldog. With this I recommend replacing your landing gear with the Ultra-Fab Deluxe Electric Landing Gear Set #UF17-943010. I prefer this over a…

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

We do not offer replacement inner tubes for jacks of that capacity. If you are unable to keep the drop leg from staying up you will need to replace the jack. We have a couple options. The Buyers Products Heavy-Duty 4" Square Jack w/ Side Pin…

The hub you have based on the numbers you mentions is the #8-201-9UC3-EZ which is a 6,000 lb axle hub. The grease seal needed then is the #GS-2125DL you mentioned.