Result: 02420

I do have several replacement parts available for the RAM Trailer Jack part #TJD-7000S but not an all inclusive rebuild kit. Instead you will need to select from the components listed below and repair the jack as needed. The most common fault on the…

I have a solution for you but there isn't just a replacement converter section for the Elixir ELX-45. You're going to need to replace the entire panel with the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger item…

The Draw-Tite 41954 Class V hitch which we offer as part #DT35MR is designed for 2015 - 2022 Ford F-150 models that aren't equipped with a factory hitch. I've made up a diagram showing the dimensions and hole spacing for you.

Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…

Hey Matthew! Thanks for providing that axle information. I reached out to Lippert and for bearings you need the Timken #TMK44FR and #TMK75FR. From what they said, your axle came with an oil bath setup so for the seal you need the Unitized Oil Seal…

The correct nut for the Dexter Shackle Bolt for Double Eye Springs part #007-126-01 is the Replacement Flange Nut for Dexter Trailer Suspension Kits part #006-092-01.

This does happen every now and then, but you will need the Dexter Replacement Emergency Breakaway Cable Kit #DX64XR. This is specifically for the A-60 actuators, which the #DX56FR is. With that said, on the bottom or underneath side of the inner…

The #SP-210275 you were looking at is for a 3500lb axle and is 27" long measured from center of spring eye to center of spring eye. This is the correct spring for your trailer based on the measurements you provided. The next shortest spring…

We do not offer replacement inner tubes for jacks of that capacity. If you are unable to keep the drop leg from staying up you will need to replace the jack. We have a couple options. The Buyers Products Heavy-Duty 4" Square Jack w/ Side Pin…

Hey Ben, yeah it sounds like your trailer has a 3,500 lb capacity axle based on what you mentioned so the correct disc brake kit part #T2HRCM10DAC that you referenced does fit.

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

Is this occurring with the trailer plugged in or was it unplugged? If it's happening with the trailer plugged in, the likely cause is a short in the trailer wiring. You'll want to examine the running light circuit, which is usually a brown…