Search: timken trailer bearings races seals caps   >   Trailer Hubs and Drums   >  

Hey Kenny, yes the Dexter Equalizer kit part #K71-359-00 will work on your 2009 EZ Loader trailer. The dimensions match or in some cases are very close to matching. You wouldn't see any significant differences in geometry or ride height either.

Hey Dave, what you gave me is enough info to get you replacement bearings. The grease seal 471750 matches the part #TMK48ZR. For a Timken replacement for the L44610 part number you'd need #TMK63VR. Then for a bearing for the L44649 you'd want…

After speaking with EZ Loader what you have on your trailer is a 3,700 lb axle. From what they said the axle was upgraded even though your overall trailer capacity is 3,100 lbs. Although this uses the same #L44649 outer and #L68149 inner bearings,…

The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit #TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.

I have included a diagram below with the measurements of the #K71-359-00 equalizer. The shackle links included with this kit are 2-1/4" long when measured center hole to center hole. The kit is intended for use with 1-3/4" wide double eye…

The Dexter bearing kit part number K71-717-00 that you referenced is the bearing kit for a number 84 spindle. Our part number for that bearing kit is #BK2-100.

I have tried to contact and have left many messages for EZ Loader to get the information on your bearings and seals. Unfortunately they haven't returned any call or email, so the best way to help you is to have you pull one of the hubs off your…

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your…

Though we do have the Bearing Buddy #BB2441T-SS that is a direct replacement for Tie Down's Turbo Lube oil baths, this will require you changing over to grease instead of oil. With that said, we do also have the Kodiak XL ProLube Kit…

The Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles - 3,500 lb with #84 Spindle #BK2-100 falls under the etrailer brand. This kit includes the common bearings and seal for a standard 3,500 lb axle.

Although there are standard bearing and seal combinations, sometimes (especially on older trailers) the "correct" seal won't fit, as you have found out. The closest seal that we have to the 1.654 Inner Diameter (ID) that you measured is…

Yes, the Bearing Kit #BK2-100 does come with the tang washer and everything you see in the picture I attached. I attached a review video that shows everything included as well.