Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to…
view full answer...It sounds like you are on the right track for tracking down where the issue is. That said, the integrated brake controllers they were putting in trucks around 2008 weren't as reliable as the ones they've been installing since then.…
view full answer...The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.
view full answer...Basically you want the tow bar to set as level as possible when flat towing. You have 3 inches up and down that is considered safe. Check out the picture I attached that shows what I mean. I also attached a help article that covers how to pick out…
view full answer...There are a few troubleshooting steps to help you figure out why you have no power. I would start by making sure that there is not any corrosion or debris blocking your connection points. If they are clean or still no power after cleaning, I would…
view full answer...In regards to the Curt Trailer Hitch Receiver part #C13416 which is a fit for a 2021 Toyota RAV4, the hitch pin hole is about 5" behind the rear bumper. The distance to the hitch ball would be dependent on the length of the ball mount. I am…
view full answer...We haven't had the opportunity to install the #EH97FR EcoHitch as of yet, but hen we installed the Curt #C13416 on a 2021 RAV4, we found that the inside top edge of the receiver tube sat about 12 inches above the ground, which would place the…
view full answer...For your application I recommend checking out the etrailer Trailer Hitch #e23ZR along with the Curt Wiring #C56434 and mounting brackets #18144 and #C57202 so the 4-Way can sit next to the receiver. It doesn't look like anything has been…
view full answer...The Draw-Tite #DT82QR and the Curt #C13416 will offer the same 9-1/2 inches of ground clearance under the bottom of the receiver tube. I don't have that figure for the EcoHitch #EH97FR as we haven't installed one yet, but the ground clearance…
view full answer...Yes, the etrailer Hitch Receiver item #e23zr will fit your 2022 Toyota RAV4. This is a custom fit hitch that bolts directly to your RAV4's frame with included hardware. You will have some limitations at the center of the hitch where the receiver…
view full answer...I recommend the Class III Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit part #DT82QR for your 2020 Toyota RAV4 which is a concealed cross tube design. The hitch will not be completely hidden once installed though. You will see the receiver…
view full answer...The Draw-Tite #DT82QR will actually fit all options for the 2021 RAV4. I included an install video we did on a 2023 RAV4 for you to check out as well. I'm not sure if it was an all wheel drive or not, but it will install exactly the same way.
view full answer...Related Searches
Filter Your Search
Contact and Help