Replacement Lens Recommendation for the Square LED Trailer Clearance, Side Marker Light # MCL36RB

Question

Question:

Do you sell only the red lens or it comes with all the light?

asked by: Maxime P

1

Helpful Expert Reply:

Yes, the correct replacement lens for the Square LED Trailer Clearance, Side Marker Light # MCL36RB that you referenced is the part # A36RB.

I pulled the two products from our warehouse to confirm this.

expert reply by: Jameson C

1

Answer 1

I can't tell you if they're a definite fit but I can certainly give you all the measurements so that you can easily find out. #A36RB is 2-13/16 inches wide, 2-1/16 inches tall, and the mounting holes are 2-3/8 inches apart. #A35AB is 2-7/8…

view full answer...

Answer 2

The correct replacement lens for the Square LED Trailer Clearance, Side Marker Light with Reflector, Stud Mount, 6 Diode part #MCL36RB is the Replacement Red Lens for MC36RB Trailer Lights part #A36RB.

view full answer...

Answer 3

Replacement lens #A36RB measures 2-1/16 inches tall, 2-3/16 inches across, and the holes are 2-3/8 inches apart on center.

view full answer...

Answer 4

Hey Remi, if what you need for your trailer taillight lens is the part #A36RB a better solution would be the part #55-15R which is same lens except it comes with the needed screws too so you wouldn't need to source them elsewhere.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...