How Waterproof is the Over 80" Wide, Square LED Trailer Tail Light # STL2RB
Published 10/21/2014 >
Products Featured in This Question
Question:
Reading the description it says weather tight and corrosion resistant. How well is this light sealed for use on a boat trailer that will be used in saltwater? It says it comes with a gasket to make it watertight, if the gasket fails are the LEDs sealed inside the enclosure? I want the most waterproof light for a trailer that is over 80inch and can be mounted to 2inch studs, is this it?
asked by: Chris B
Expert Reply:
The Over 80" Wide, Square LED Trailer Tail Light # STL2RB that you referenced is designed to be a submersible light. What that means is that once you got to the boat ramp you would want to disconnect your trailer wiring from your tow vehicle and then you could back your boat trailer into the water and the lights will be totally fine. The LEDs are sealed so that water would not get to them.
This light would be exactly what you need. For the left hand side you would want part # STL3RB.
Product Page this Question was Asked From
LED Combination Trailer Tail Light - Submersible - 7 Function - 18 Diodes - Square - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Clearance
- Rear Reflector
- Side Marker
- Side Reflector
- Stop
- Tail
- Turn
- Square
- Surface Mount
- Submersible Lights
- LED Light
- 6-1/8L x 4-9/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Search Results: trailer wiring
- Search Results: trailer lights
- Shop: LED Combination Trailer Tail Light - Submersible - 8 Function - 21 Diodes - Square - Driver Side
- Q&A: Troubleshooting Right Turn Signal Not Working on Trailer Taillights
- Shop: LED Combination Trailer Tail Light - Submersible - 7 Function - 18 Diodes - Square - Passenger Side
- Search Results: pollak trailer wiring
- Shop: Pollak Black Plastic, 7-Pole, RV-Style Trailer Connector - Trailer End
- Shop: Tail Light for Trailers Over 80" Wide - 7 Function - Incandescent - Square - Passenger Side
- Shop: Tail Light for Trailers Over 80" Wide - 8 Function - Incandescent - Square - Driver Side
- Shop: etrailer 7-Way RV Style Connector with Molded Cable - Trailer End - 6' Long - RV Standard
- Shop: Peterson Combination Trailer Tail Light - 6 Function - Incandescent - Square - Passenger Side
- Video: Complete Breakdown of the Trailer Wiring Junction Box
- Search Results: pollak custom fit vehicle wiring
- Search Results: wire cover
- Search Results: 7 wire coiled
- Search Results: 7 way wire junction box
- Q&A: What Wire Gauges does Bargman 7-Way Molded Trailer End Connector and Cabel Use
- Q&A: Does the Replacement Tail Light Lens # AL8RB-1G Go to a Light with License Plate Function
- Q&A: Recommended Replacement Driver & Passenger LED Combination Trailer Tail Lights
- Q&A: Troubleshooting Trailer Tail Light Not Working On New Utility Trailer
- Q&A: Drivers Side Light To Match Passenger Side STL2RB
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Should Battery Be Disconnected When Relocating Break Away Switch?
- Article: Trailer Lighting Requirements
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle

