Adding Side Marker Lights to Open Utility Trailer
Updated 09/02/2014 | Published 08/30/2014
Products Featured in This Question
Question:
are you allowed to add more side marker lights to a open utility trailer
asked by: Sheamus W
Expert Reply:
Yes, side marker lights can be added to your open utility trailer. When adding these lights you will just need to make sure that you do not exceed the amp rating of the trailer wiring harness.
In an effort to add lights to your trailer without exceeding the amp rating of the trailer wiring harness, I recommend going with an LED light like the Double Bullseye LED Trailer Clearance and Side Marker Light, # MCL45AB. This light draws a mere 0.087amps at 12.8 volts.
Product Page this Question was Asked From
Optronics Mini Trailer Clearance or Side Marker Light - Submersible - Incandescent - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Submersible Lights
- Incandescent Light
- 2-1/16L x 1-1/16W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Can The Bulb Be Replaced On The Optronics Mini Trailer Clearance or Side Marker Light MC95AB?
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: How To Measure For Replacement Overhead Springs On A Trailer Door
- Q&A: ABS Error Warning Light on 2018 Toyota Highlander When Installing Trailer Brake Controller
- Article: Trailer Wiring Diagrams
- Q&A: Mounting Hardware to Use with CE Smith Fender # CE19502
- Q&A: LED Trailer Taillight Kit Recommendation for 2000 Ranger Boat Trailer
- Q&A: Replacement For 125255UC Grease Seal
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Printable Trailer Bolt Hole Pattern Template