Hitch Recommendations for a 2003 Chevy Silverado  

The receiver tube on the Curt Class V hitch #C15302 does not have any reinforcement around the hitch pin hole. I went to our warehouse and checked this hitch to be sure. When this feature is included on a hitch it will usually be easy to see since it…

When installing the Curt hitch part #C15302 you do need to reuse the factory 14 mm bolts that the factory hitch was using but since you have lost yours you could get replacements from a dealer or find matching bolts at a hardware store.

With Curt Trailer Hitch Receiver #C15302 installed on a 2003 Chevy Silverado 2500 short bed the hitch will be in the same position as a factory hitch or at least within a fraction of an inch. By that I mean the receiver will be right under the rear…

Both of the Curt hitches that you listed are confirmed to fit your 2009 Chevrolet Silverado 2500HD. The difference between the two can been seen in these hitches' features. The Curt Class V Hitch #C15302 that uses the 2 inch receiver opening, is…

The Curt hitch part #C15302 which fits your 2006 GMC Sierra 2500 would occupy the same amount of space as your factory hitch so if your current spare fit with it would also fit with this hitch.

There are quite a few holes on the frame of your 2002 Chevy Silverado 2500HD short bed that hitches can attach to like the Curt you mentioned part #C15302. This is why the hitch fits for your truck have a few different bolt hole variations. I…

Yes, the Curt Trailer Hitch Receiver #C15302 does not have the bolt holes that also secure it to the bumper on your 2009 Chevrolet Silverado 2500HD with the short bed. This is fine as the construction for this receiver is much stronger than that on…

The Curt hitch part #C15302 that you referenced does not come with a trailer wiring bracket. You would just need to order the part #PK12711U along with it. I attached an install video for the bracket for you to check out as well.

The Curt Hitch part #C15302 will fit very tight to your rear bumper. It would be hard for me to venture a guess as to how much higher it would sit than your factory hitch. But I can give you a way for you to figure it out. When installed, the #C15302…

For your 2002 Chevy Silverado you will need to go with a hitch that will fit trucks that do have a factory trailer hitch. For that you would want the Draw Tite hitch part #41944 which will fit your truck once you remove the factory hitch. This…

Yes, the spare tire will get lowered - but only temporarily - when you are installing the Curt Trailer Hitch Receiver #C15302. After you complete the install and torque the bolts down of the Curt Hitch #C15302, you will then raise and reinstall the…

For your 2005 GMC Sierra 2500HD short bed the Curt Class V hitch part #C15302 is a confirmed fit and would work well. It has towing capacity of 16,000 lbs which would be more than what your truck is rated for.