Installing a Brake Controller in a 2014 Ford Escape
Updated 07/21/2014 | Published 07/19/2014
Products Featured in This Question
Question:
I need to know if can splice into the brake switch cold side.
asked by: Eric
Helpful Expert Reply:
To install the Tekonsha Voyager Brake Controller part # 39510 in your 2014 Ford Escape you will need to splice into the cold side of the brake switch with the red wire of the controller. I attached a video that shows a brake controller being installed on a very similar Ford Escape as your 2014 model.
In case you aren't sure what parts you would need you also would need a 4-way to start. For that you would want the # C56335. Now to convert that to a 7-way and install the brake controller you will need the part # ETBC7. I attached install instructions for these products for you to check out also.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: prodigy p2
- Shop: Brake Controller
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Q&A: Trailer Wiring Harness for a 2013 Ford Escape without Factory Tow Package
- Search Results: trailer brake controller
- Search Results: 4 to 7 adapter
- Search Results: tekonsha p2
- Search Results: 4 pole to 7 pole
- Search Results: 47185
- Shop: Pollak 7 Pole to 4 Way Connector Adapter
- Shop: EZ Connector Magnetic 7-Way Trailer Connectors w/ Watertight Seal - Custom - Vehicle/Trailer End
- Q&A: How to Hard Wire Prodigy P2 Trailer Brake Controller
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Q&A: Parts Needed To Add Electric Drum Brakes To A Trailer
- Q&A: Can Electric Over Hydraulic Brake Actuator Be Fully Submerged
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Adding Electric Over Hydraulic Disc Brakes to Boat Trailer
- Q&A: Parts Needed To Replace Surge Coupler For Disc Brakes With Electric Over Hydraulic