What Size Mounting Bolts are Needed to Install the Curt 7-Way RV-Style Trailer Connector C58155?
Updated 01/27/2026 | Published 12/31/2025
Products Featured in This Question
Question:
What size bolts or hardware does the item C58155 use?
asked by: Felix C
0
Expert Reply:
Hey Felix, welcome back. To install the Curt 7-Way RV-Style Trailer Connector item # C58155, you'll want to use four .19" diameter x 1" long bolts and nuts. This will secure it to the Curt Mounting Bracket item # C67UR, you purchased.
I recommend using some Loctite Threadlocker 242 item # LT37418 when you bolt the 7-way to the bracket.
If you have any additional questions, go ahead and click on the box below that says Reply to Jerred H and I'll be happy to answer them.
expert reply by:
Jerred H
0
C58155
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Curt 7-Way RV-Style Trailer Connector - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- CURT
more information >
Continue Researching
- Q&A: What Is The Smallest Available Spindle Nut For 2.5k Axle?
- Q&A: What Bearing Kit do I Need for My 2025 Alliance Delta 252rl with 2 Axles Rated for 3,500 Pounds?
- Q&A: Can The Lock Core Of A Bauer Products Compression Latch Be Removed And Replaced
- Q&A: Replacement for Valterra Waste Valve on 2017 Grand Design Reflection 26RL
- Q&A: Location of the Brake Controller Port on a 2008 Dodge Ram
- Q&A: EOH Actuator and Brake Lines For Nucamp Tag XL Boondock Adding Disc Brakes
- Q&A: Recommended Replacement For An Atwood GC6AA-10E Water Heater
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Best Vehicles to Flat Tow Behind an RV
Jerred H.
1/27/2026
Hey Felix, how did the bolt setup go when you mounted the Curt 7-way connector to the bracket? Your update could make it easier for the next person working on the same connection.