Tongue Jack for Chipper With 2" Square Tongue

Updated 10/30/2025 | Published 10/07/2025

Question:

Need tongue jack for chipper to 4x2 gator with installed tang clevis hitch bar. 10 inch from floor to top of hitch plate. 2 square tongue. 10 to bottom of tongue need side wind, swing back, 500 to 1000lb lift. I can send image if needed. Tongue came with removable 7 swing back stand Will this fit a 2inch square tongue?

asked by: William E

Expert Reply:

Hey William! The etrailer Boat Trailer Jack w/ Wheel # MJ-1206B fits trailer frames 2" to 4" tall so it will work with your 2" square tongue. It looks like this has all of the features you're looking for and a high enough capacity so it will be a good fit for your trailer. It has a retracted bracket height of 13-1/2" with 10" of screw travel and comes with a 1-year warranty.

expert reply by: Robin H

etrailer Boat Trailer Jack
(click to enlarge)

Robin H.

10/30/2025

Hey William, how did the etrailer boat trailer jack work out on your 2-inch square tongue? It sounds like it matched your height and lift needs well. Sharing how it performed could help others setting up a similar trailer.

William K.

10/30/2025

@RobinH It turned out that DR, conrary to what CS. had.said, had a jack specifally made for the trailer. That solved my problem. I really appreciated your determination to help me. That does not often and happen and be sure etrailer will be on my highly recommended list!