Trailer Jack Recommendation for a Bandit Chipper with a Square Pipe Mount
Updated 04/17/2013 | Published 04/15/2013
Question:
My trailer has a square tube on the side instead of a round one mine has the hole for the pin also is there a way you can get me one like mine..Thanks it goes on a bandit chipper
asked by: Danny C
Expert Reply:
We have two Bulldog jacks that use the square pipe mount attachment. We have the Topwind Swivel Jack, # BD195312, and the Sidewind Swivel Jack, # BD195362. Both of these jacks have a 15 inch lift, a 3,000 lb lift capacity and a 5,000 lb static weight capacity.
For these jacks to fit on your chipper, the square pipe mount on your chipper must measure 2 inches x 2 inches. You should also note the retracted and extended heights of the jacks to make sure they will not be too short or too long for your trailer.
When fully retracted, these jacks measure 15-1/8 inches from the center of the square pipe mount to the bottom of the foot plate. When extended, they measure 30-1/8 inches. I have attached video for you to check out showing these dimensions.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: dexter brake caliper
- Search Results: dexter caliper
- Search Results: bd195362
- Search Results: 195312
- Shop: Replacement Caliper for Dexter Disc Brakes - Left Hand or Right Hand - E-Coat - 8,000 lbs
- Shop: Dexter Disc Brake Assembly - 12-1/4" Rotor - 8 on 6-1/2 - E-Coat - 8,000 lbs
- Shop: Replacement Caliper for Dexter Disc Brakes - Left Hand or Right Hand - E-Coat - 6,000 lbs
- Search Results: bulldog trailer jack
- Search Results: trailer jack
- Shop: Bulldog Round, A-Frame Jack Drop Leg and Pull Pin Assembly
- Shop: Square Pipe Mount Swivel Trailer Jack w/ Foot - Sidewind - 15-1/4" Lift - 3,000 lbs
- Video: etrailer Jack Sidewind Handle Assembly Replacement
- Shop: RV Interior Lighting
- Shop: Opti-Brite 12V LED RV Dome Light - Single - 5-3/4" Long x 2-3/4" Wide - Silver Housing
- Shop: Opti-Brite 12V/24V LED Dome Light for Refrigerated Trucks and Trailers - Motion Sensor - Clear Lens
- Q&A: Recommended Square Bulldog Jack with 5,000 lb Capacity
- Q&A: Instructions for Disassembling a 12,000 lb Bulldog Jack
- Search Results: fulton magnum series jack
- Video: A Closer Look at the Square Pipe Mount Swivel Jack w Footplate
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Shop: Trailer Wiring
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Suspension Enhancement
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
on Trailer Jack
