Can Bulldog Square Swivel Jack w/ Square Pipe Mount # BD195362 Be Used on Dovetail Trailer

Question

Question:

I have a 2019 corn pro gooseneck trailer with an adjustable dovetail. I’m looking for a jack that will lift and lower the dovetail when needed. Thanks

asked by: Aric

0

Expert Reply:

While our trailer jacks were intended for the front of trailers I found several forums online that use swivel pipe mount jacks like the Bulldog Square Swivel Jack w/ Square Pipe Mount # BD195362 you referenced at the rear of the trailer to provide additional support for the rear of it.

This is one of the higher weight capacity jacks out there so for your application this would be the best possible solution. I attached a review video for this for you to check out as well.

expert reply by: Jameson C

0

Answer 1

Hey William! The etrailer Boat Trailer Jack w/ Wheel #MJ-1206B fits trailer frames 2" to 4" tall so it will work with your 2" square tongue. It looks like this has all of the features you're looking for and a high enough capacity…

view full answer...

Answer 2

We have two Bulldog jacks that use the square pipe mount attachment. We have the Topwind Swivel Jack, #BD195312, and the Sidewind Swivel Jack, #BD195362. Both of these jacks have a 15 inch lift, a 3,000 lb lift capacity and a 5,000 lb static weight…

view full answer...

Answer 3

The female version of the Bulldog Replacement Pipe Mount for Swivel Jacks #BDPQM1900 isn't available separately and only comes already installed on the trailer jacks, like what we see with part #BD195362. If you're needing a weld-on bracket…

view full answer...

Answer 4

I pulled the Bulldog square swivel jack #BD190758 from our warehouse to provide the measurements you requested. The jack is 26-inches in overall length, not including the handle. The handle radius is 8-1/2 inches for your reference. If the foot base…

view full answer...

Answer 5

I went to the warehouse and measured a couple of the Bulldog Square Swivel Jack w/ Square Pipe Mount part #BD195362 for you. They are very consistent in the measurements. See the included photo for the dimensions you are looking for. If I missed…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Can Bulldog Square Swivel Jack w/ Square Pipe Mount # BD195362 Be Used on Dovetail Trailer

Featured Help Information

Miscellaneous Media

Continue Researching