Recommended Trailer Jack With Wheel for 2.5 x 2 Inch Trailer Tongue

Question

Question:

My utility trailer has a tongue that is 2.5” wide and 2” high. Which trailer jack should I get?i would like one that swivels and has a wheel. Thanks!

asked by: Jennifer

1

Helpful Expert Reply:

For your 2.5 inch wide and 2 inch high trailer tongue, the Round Swivel Marine Jack w/ Wheel - Bolt On - Zinc - Sidewind - 11" Travel - 1,500 lbs # MJ-1500B is my recommendation. It will work very well with the trailer tongue you have and will give you 11 inches of travel from the 13 inch retracted height. I've attached a photo to assist as well as a couple videos.

expert reply by: Jason S

1

click to enlarge

Answer 1

While the cost of the Round Swivel Marine Jack #MJ-1500B is relatively low it still is a quality trailer jack. We get a special price on this since it's our house brand of jack but it will function and last just as long as the other more…

view full answer...

Answer 2

I wasn't able to get a CAD drawing for the Fulton Bolt-Thru Swivel Marine Jack #FXPD15L that you referenced (manufacturer's don't typically make those available), however I did go out to our warehouse to take a few measurements on the…

view full answer...

Answer 3

The etrailer Round Swivel Marine Jack, #MJ-1500B may replace a Fulton F2 depending on your current bolt hole dimensions. The Marine Jack has eight different bolt holes, as you can see in the photo I've attached. The mounting bracket itself is…

view full answer...

Answer 4

I can see you have a Fulton Bolt-Thru Trailer Jack so you can replace this with the Fulton Bolt-Thru Swivel Marine Jack part #FXP10W0301 which is a direct bolt-on fit and has a 1,200 lb weight capacity. Then for the Fulton XLT1401 Winch, I recommend…

view full answer...

Answer 5

Hey William! The etrailer Boat Trailer Jack w/ Wheel #MJ-1206B fits trailer frames 2" to 4" tall so it will work with your 2" square tongue. It looks like this has all of the features you're looking for and a high enough capacity…

view full answer...

Answer 6

Hey Frank, the radius for the handle of the etrailer jack part #e22ZV is 8-1/8 inches. That means it sticks out 8-1/8 inches from where it attaches to the jack. From the center of the jack mount to the top of the jack measures 7.5 inches.

view full answer...

Answer 7

Hello Ross, thanks for reaching out. For the etrailer Swivel Jack w/ Bolt-On Mounting Plate #e22ZV the distance from the bottom of the pipe mount bracket to the bottom of the jack when fully retracted is 8". I edited a picture to illustrate. Let…

view full answer...

Answer 8

Hey Robrt, thanks for reaching out! Yes, the etrailer Swivel Jack w/ Bolt-On Mounting Plate #e22ZV can be installed on angle iron, but I do recommend beefing up that attachment point a little instead of just running 2 bolts through it and calling it…

view full answer...

Answer 9

Hey Steve, is the height from the bottom of the mounting plate? If so, then I think the Fulton #FTJ120W0301 would work for what you are looking for as it has the shorter height below the mount and has a wheel caster.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Recommended Trailer Jack With Wheel for 2.5 x 2 Inch Trailer Tongue

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching