What is the Weight Capacity of the etrailer Swivel Jack w/ Bolt-On Mounting Plate

Question

Question:

Is the weight capacity 3000 pounds total or 3000 pounds per Jack?

asked by: Scott

0

Expert Reply:

Hey Scott!

The etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates # e94RV are rated for 3,000 lb individually so they can collectively support 6,000 lbs.

Are you planning on using these on the same trailer, or dividing them between 2 different trailers?

expert reply by: Jon G

0

Scott

9/4/2025

Job, I would use on the same trailer. Thanks for the information.

Reply

Jon G.

9/4/2025

@Scott Happy to help out!

Reply

Answer 1

Hey Josh, the dimension for both jacks that you are looking for is the bracket height. This is the distance from the center of the jack's mounting bracket down to the ground when extended/retracted. On the shorter part #e34RV the bracket height…

view full answer...

Answer 2

Hey Ed, The etrailer Swivel Jack w/ Bolt-On Mounting Plate #e54RV will come with the pin chained to it so that you can't lose it. I believe the instructions for this jack were prototype phase instructions and not final product where the pin was…

view full answer...

Answer 3

Hey Thomas, what kind of trailer do you have? Planning any cool trips when the weather warms up? The etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates #e34RV measures 20 1/2" from the bottom of the jack foot to the underside of the 90°…

view full answer...

Answer 4

Hey Matt, thanks for reaching out! I spoke with my contact at Lippert and that particular piece of the arm isn't available as a replacement part, so we'll need to get you setup with a whole new arm assembly. The correct replacement for your…

view full answer...

Answer 5

Hello Don, Great question, and thank you for the picture. I would cut the trim. Adding a plate or shim can introduce a weak spot and may also lead to increased vibration while traveling. Plus, you want the etrailer Bolt-On Swivel Mounting Plate for…

view full answer...

Answer 6

Hey Steve, on the etrailer jacks part #e34RV the distance from the bottom of the mounting plate down to the ground is 10-1/4 inches retracted and 20-1/4 inches extended.

view full answer...

Answer 7

The fully extended length of the #TJ01RT-HD stabilizer jack would be 18 inches, which represents the 'A' Dimension in your photo. The 'B' dimension would simply be the height above the ground of the underside of your trailer when its…

view full answer...

What is the Weight Capacity of the etrailer Swivel Jack w/ Bolt-On Mounting Plate

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching