Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Add a backing plate to your tandem-axle trailer fender (HP24VR) to block water and road debris from hitting the side of your trailer. 18-Gauge steel is durable.
Features:
Specs:
Note: Backing plates are not to be used for mounting your fender.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello everybody, this is Jeff at etrailer.com. Today we can take a look at the pre-cut steel backing plate for the Tandem Axle Trailer Fenders. Now this backing plate will help protect the side of your Tandem Axle Trailer from any water or road debris and this backing plate is precut, you can see, to easily fit the Tandem Axle Trailer. It is designed to fit a Tandem Axle Trailer Fender that has a 90 degree back and we do sell the fender separately on our website. It's part number HP44VR and it's listed on this product page as a related product. And when I mentioned that it has a 90 degree back basically what that means is the back edge of the fender that goes up against the trailer will have a 90 degree bend to it.
And that then gives us an area that this backing plate can be up against and be welded to. It will also fit other fenders that basically have a total length of 72 inches and a height from bottom to top of about 20 and a half inches. Now this backing plate itself is a sturdy 18 gauge steel construction. It is made in the USA. A few dimensions on this backing plate itself, if we go length wise from one end all the way to the other end and I get it on the end there and then all the way to this end that's right at 68 and seven eighths inches long.
And the overall height from the very bottom to the very top is right at 12 inches tall. And this part is for a quantity of one backing plate. But that should do it for the review on this pre-cut steel backing plate for the Tandem Axle Trailer Fenders..
Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews
Sierra K.
12/6/2021
The back plates are 18-gauge steel. It is recommended to use .023 wire in your mig welder to avoid blowing holes in the material.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Katrina B.
8/29/2022
This is not good at all! I have sent your information over to our customer service department for them to better assist you.