Recommended Brake Controller For 2004 Toyota Sienna

Question

Question:

Hi, How are you? I am trying to install electric brake controller for my toyota sienna 2004. On your web site, 2004 sienna is not included in pull-down menu. Which controller is best suited for my van if there are any. Thank you for your help.

asked by: Jun S

0

Expert Reply:

Brake controllers are not vehicle specific, so it is a matter of personal preference on which controller you choose for your 2004 Toyota Sienna. I recommend using a proportional brake controller. A proportional controller will activate the trailer brakes in proportion to your vehicle's braking action.

The Tekonsha Primus, part # TK90160 is an excellent controller at a great price that would be an excellent choice for you unless the trailer you're pulling has an electric over hydraulic braking system. For a trailer with electric brakes, the Primus would work well.

To install the controller, you'll need a Brake Controller Installation Kit, part # ETBC7. The kit contains everything needed to install the controller, but the vehicle will need to be equipped with a functioning 4-pole connector like part # 118304, if it doesn't already have one.

I have attached a link to the instructions for the ETBC7 kit, as well as to a video showing the kit being installed you may want to check out. Even though the vehicle shown is different, the installation on your Sienna would be very similar.

expert reply by: Jeffrey L

0

Answer 1

If I have misunderstood your question in any way, please let me know. It sounds like you have electric trailer brakes and need a brake controller that you can use on two different vehicles. The perfect option for this is the Curt #C51180 Wireless…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 10

Hello William, Thanks for writing in, you are correct the Firestone #F4155 is not a good fit for the 2021 to 2024 Sienna Hybrid. The hybrid models have some key differences in the rear suspension area due to battery placement and tighter coil spring…

view full answer...

Answer 11

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 12

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Recommended Brake Controller For 2004 Toyota Sienna

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching