Will the Footplate on You etrailer Weight Scale Also Work on the etrailer Round A-Frame Trailer Jack

Question

Question:

I purchased part e99044 tongue weight scale that came with a foot pad. Will it fit and work on this manual jack partTJA-5000S-B?

asked by: Earl

0

Expert Reply:

Hello Earl,

Both the etrailer Tongue Weight Scale for Campers and Utility Trailers - 2,000-lb Capacity # e99044 and the Round A-Frame Trailer Jack - Sidewind - 15-5/8" Travel - 5,000 lbs # TJA-5000S-B have a 2" inner diameter tube, so YES you can use the foot from the scale on the jack as well.

What kind of trailer is this going on?

expert reply by: Kate F

0

Kate F.

9/2/2025

Hey Earl, Did you get a chance to try the foot pad from the tongue weight scale on your manual jack? I'm curious to know how it worked out for your trailer setup. Your experience could really help others with similar questions.

Answer 1

Hey Michael! The etrailer Electric Trailer Jack w/ 7-Way #e74GV you were looking at will definitely have enough lift for your Coleman 13R. This is a great option if you just want to power the jack off the 7-way on your vehicle instead of running it…

view full answer...

Answer 2

Hey there Greg! The etrailer Electric Trailer Jack - Drop Leg - A-Frame - 18" Lift - 5,000 lbs #e55ZV has a measurement of 4-3/8" from the outer tube to the furthest point of the head. This tells me you should be good to go, but just…

view full answer...

Answer 3

Hey Leonard! Yes, you can use the hitch pin hole furthest away from the head to install the Andersen Weight Distribution Hitch #AN53VR in your receiver. Both of the hitch pin holes can be used to secure the shank. What kind of trailer are you…

view full answer...

Answer 4

Hey Chris! The black wire on the etrailer Electric Trailer Jack #e23ZV is just a ground wire. Realistically you can ground it however you want but I would say running it to the frame with a self-tapping screw as indicated in the instructions is the…

view full answer...

Answer 5

There is a Bulldog jack that has numerous bolt holes to allow you to unbolt the jack and rotate it 90 degrees, the Bulldog Powered Drive Trailer Jack #BD500199. You can see an example of this in the linked video - just forward to about the 6:15 mark.…

view full answer...

Answer 6

Hello Jeremy, Yes, our etrailer jack #e55ZV will automatically stop and not over raise. If you check out the video that I attached you will see that Steven still has his finger pushing down the button after the jack stops. What kind of application…

view full answer...

Answer 7

We do not carry that jack so I am unfamiliar with it specifically, but to wire an electric jack in general one of the wires will be powered from a battery mounted on the trailer that is maintained by your tow vehicle's 7-way while the other wire…

view full answer...

Answer 8

You are correct, the red power wire coming out of the Lippert jack #LC285318 will need to be connected to the positive terminal on your trailer battery to provide a 12V power source. The jack is grounded through its mounting hardware. All you need is…

view full answer...

Answer 9

Hello Ralph, thanks for reaching out. The etrailer Electric Trailer Jack #e23ZV will be a great option for you. The jack can be rotated to the side if needed. We have one of these jacks on our trailer here at the shop and I have seen it rotated and…

view full answer...

Answer 10

Yes, you can rotate the Lippert Electric Trailer Jack with Footplate part #LC285318 in one of three ways so that the controls face forward, back to the right, or back to the left. Just remove the nuts/bolts, rotates, then reinstall once you get the…

view full answer...

Answer 11

You could do either one! The etrailer Electric Trailer Jack item #e55ZV can be wired to the accessory circuit through your trailer's 7-way connector or you can connect it directly to your trailer's battery. The accessory circuit is typically…

view full answer...

Answer 12

45 PSI is as low as you can go per tire for a 3,800 lbs trailer. The Goodyear Endurance ST225/75R15 Radial Tire item #LH33FR, you were looking at, is a load range E tire with a maximum capacity of 2,830lbs at 80 PSI per tire. The air pressure can be…

view full answer...

Will the Footplate on You etrailer Weight Scale Also Work on the etrailer Round A-Frame Trailer Jack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching