How to Install the Timbren Front Suspension Enhancement System on a 2016 Toyota Tundra
Updated 07/02/2025 | Published 06/25/2025
Question:
2016 tundra 4w dr,big winch,steel front bumper.recently purchased TOFTUN4. installed it.When you look at the instructions,the middle picture is best. The bump stop screws into the factory nut.My question is how do you put the nylon lock nut on top,when there is no access above it.Its a metal arm,sealed? Thanks
asked by: Karl E
Expert Reply:
Hey Karl, welcome back. You don't have to install the # 3 nut unless you're mounting the Timbren Front Suspension Enhancement System item # TTOFTUN4 to the bottom like the 1st picture. Ideally the spring just threads into the upper weld nut on your 2016 Toyota Tundra.
Are you able to use the factory weld nuts?
(click to enlarge)
Product Page this Question was Asked From
Timbren Front Suspension Enhancement System
- Vehicle Suspension
- Towing/Load Leveling
- Bump Stops
- Suspension Only
- Extra Heavy Duty
- Front Axle Suspension Enhancement
- Timbren
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Timbren Front Suspension Enhancement System
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Q&A: Recommended Timbren Front Suspension Enhancement System For a 2017 Toyota Tundra With Snow Plow
- Shop: Timbren Active Off-Road Bumpstops - Front Suspension - 1,000 lbs
- Shop: Timbren Front Suspension Enhancement System
- Shop: SumoSprings Solo Custom Helper Springs - Front Axle
- Q&A: Could SumoSprings for Trailer Suspension be Trimmed Down
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Manufacturer Spotlight - SuperSprings Vehicle and Trailer Suspension
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Search Results: trailer tires and wheels
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer wiring
- Article: How to Measure for Trailer Hitch Drop
- Video: Pacbrake Alpha Air Bag Suspension Kit Review and Comparison
- Q&A: Firestone Air Bags for 2026 Ford F-350 FX4 Dually
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Search Results: trailer jack
- Shop: Brake Controller
- Video: How to Choose a Trailer Brake Controller
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Video: Choosing the Right Vehicle Suspension Upgrades
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Search Results: suspension enhancement
- Q&A: Do I Want Sumo Springs or Timbrens to Pair with My Weight Distribution Hitch?
on Vehicle Suspension
Karl E.
6/30/2025
Yes,got it tight in the factory nut,just wasn't sure if that was adequate.Thanks for conforming that