Replacement Trailer Roof Vent w/ Fan for a Ventline V2394 Fan

Question

Question:

I need to replace a Ventline V2394 unit. The existing fan still works. The opening is 14.25 inches by 14.24 inches. This is for a 2017 Lance 1985 travel trailer. Thank you.

asked by: Stewart E

0

Expert Reply:

Hey Stewart! To replace your Ventline V2394 fan, you'll want the Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" - White - Birch Trim item # V2094SP-28. This is almost an identical set up that will drop right into the cutout your V2394 fan occupies now.

You'll also want to pick up the Roof Vent Installation Kit item # 344270KITW, which includes everything you need to not only install but reseal your vent.

Why are you wanting to replace your Ventline V2394 if the fan still works?

expert reply by: Jerred H

0

Ventline Ventadome
(click to enlarge)

Stewart E.

5/28/2025

The handle to raise the dome is broken and the sun has done a real number to the unit.

Jerred H.

5/29/2025

@StewartE Definitely sounds like it's ready to be replaced. Are you wanting to stick to something similar to yours or are you wanting to upgrade to a fan with more features?

Stewart E.

5/29/2025

@JerredH I’m open to options.

Jerred H.

5/29/2025

@StewartE Yeah, we've definitely got those. Check out these two fans I have listed below: MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke item # MA00-07500K MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat - Manual Lift - 10 Speed - White item # MA00-04000K

Stewart E.

5/29/2025

Did you see my question about a shower surround?

Jerred H.

5/30/2025

@StewartE No, I did not see a question about a shower surround. What are you looking for?

Answer 1

I recommend using the MaxxAir II RV and Trailer Roof Vent Cover #MA76JR as it is easily removable allowing you to easily clean under the cover and check the sealant. If you are only needing a lid you will need either the Pre-2008 #BV0554-01 lid or…

view full answer...

Answer 2

I am afraid we are not able to tell specifically what model of FanTastic vent you have based on your pictures. It certainly appears to be an older model. If you are looking to replace individual parts of your fan we will need to know the exact model.…

view full answer...

Answer 3

The most beneficial component that you can add/upgrade to help eliminate sway is an anti-sway bar, the Roadmaster Rear Anti-Sway Bar part #RM-1129-135 in particular. The Roadmaster Rear Anti-Sway Bar will replace your factory sway bar and because it…

view full answer...

Answer 4

Hey Jim, yeah the MaxxFan roof vent part #MA00-04002K would do a great job as a bathroom fan unlike what you have now as it can move a lot of air.

view full answer...

Answer 5

We have had a similar question to this come up and we were able to determine that the number AS-13 M-VDO449 that you listed is stamped on the vent cover part #BVD0449-A01. If you are looking for the entire fan setup and not just the cover you would…

view full answer...

Answer 6

Hey, Jim. At this time, Furrion doesn’t offer a specific air deflector to redirect the airflow on the Chill Cube ducted air distribution box #LC64DX. That said, there are some third-party stick-on air diverters out there that can help redirect the…

view full answer...

Answer 7

Hey Dustin, the replacement lid you ordered a few years ago was the part #BVD0449-A01. I know it sucks yours fell apart but these aren't really designed to withstand a hail storm so I am not shocked yours broke apart. Would you prefer metal lid…

view full answer...

Answer 8

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 9

Hey Ray, thanks for reaching out. Yes we do have a good option for replacing your Dometic Duo-Therm 57915.531. With yours being an older unit, there is not a direct rooftop swap that keeps your existing controls. The correct path is replacing the…

view full answer...

Answer 10

Hey, Bill! I did some searching about the light that you currently have. Part number 1A-V-1260AR is a Kaper II light, unfortunately we don't carry that brand of light. The Peterson light part #2637R would be a comparable light. We don't have…

view full answer...

Answer 11

Hey Tony. With that short of a ground clearance, I recommend the etrailer Scissor Stabilizer Jacks w/ Handle and Drill Adapter item #e56VV. These extend from as little as 5" to as high as 24" and have a 5,000 lbs capacity. This kit comes…

view full answer...

Replacement Trailer Roof Vent w/ Fan for a Ventline V2394 Fan

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching