Could MaxxFan Plus Roof Vent be Used in Bathroom as Fan

Question

Question:

I have a Dutchmen Yukon 400rl and want to replace the fans in the bathroom area with one of these fans. Nothing directly over the shower, but something better than the small inefficient fans that are there now. Would these fans be my best bet?

asked by: Jim

0

Expert Reply:

Hey Jim, yeah the MaxxFan roof vent part # MA00-04002K would do a great job as a bathroom fan unlike what you have now as it can move a lot of air.

expert reply by: Jameson C

0

Answer 1

Hey Stewart! To replace your Ventline V2394 fan, you'll want the Ventline Ventadome Trailer Roof Vent w/ 12V Fan - Manual Lift - 14-1/4" - White - Birch Trim item #V2094SP-28. This is almost an identical set up that will drop right into the…

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 5

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 6

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

Hey Ian, great to hear from you again! The differences between the MORryde CRE3000 #MR87ZR and AllTrek 4000 #MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will…

view full answer...

Answer 9

Hey, Daniel. Thanks for your question. We do have a weight distribution hitch that would work for your trailer and still use chains. That hitch is the Blue Ox SwayPro #BXW0350. The tongue weight rating needed for this system to work is between…

view full answer...

Answer 10

Hey Mark, yes we do have a version of the Andersen part #AN88VR with a 2-5/16 inch ball instead with the part #AN53VR. What does your trailer weigh?

view full answer...

Answer 11

Hey Don, Curt does have a Class V hitch for your Ram but it sits super low so it's not going to be what you want. Draw-Tite offers Trailer Hitch Receiver #DT45509. It has a 2-1/2" receiver tube opening, 18,000lb gross towing weight/2,000lb…

view full answer...

Answer 12

Hey Delbert, thanks for reaching out! Yes, the Andersen Weight Distribution Hitch w Sway Control #AN53VR can be used for a lighter trailer like what you have. You'll just need to adjust the system to accommodate your weight and you'll be good…

view full answer...

Could MaxxFan Plus Roof Vent be Used in Bathroom as Fan

Product Page this Question was Asked From

Continue Researching