Bearing Kit that Fits Sure Trac Sure-Trac ST8218CHW-B-100 with the Lippert 5200 lb Axles

Question

Question:

I have a Sure-Trac ST8218CHW-B-100 with the Lippert 5200 lbs spring brake axles. What is the best hub/bearing kit I should have on hand as a spare? Thanks!

asked by: Zach C

0

Expert Reply:

Hey Zach, since you have a 5,200 lb trailer axle the correct bearing kit you'd need is the part # BK3-300.

In order to pick out the hub/drum you'd need I would also need to know the wheel bolt pattern of your hubs so that your wheels would fit.

expert reply by: Jameson C

0

Zach C.

5/21/2025

They are 6 on 5.5. Thanks for the help!

Jameson C.

5/21/2025

@ZachC Perfect! So for a spare hub/drum the part # AKHD-655-6-K would be most ideal. This is correct axle rating and also comes pre-greased so it would be ready to throw on if needed.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hi Richard! The best brake controllers on the market for your 2023 Ford Explorer XLT are going to be from Redarc. They're super easy to use and set up, and they are very reliable. They are the ones to get. Since you said you will be towing a…

view full answer...

Answer 12

Hey David, the Redarc Tow-Pro Link Bluetooth Brake Controller #RED57AR that you referenced will fit any vehicle that has a 7-way installed on it including your 2017 Ram 3500 that has a factory brake controller. This will bypass that circuit on your…

view full answer...

Bearing Kit that Fits Sure Trac Sure-Trac ST8218CHW-B-100 with the Lippert 5200 lb Axles

Product Page this Question was Asked From

Continue Researching