Replacement Spring Bars for Fastway e2 Round Bar WDH

Question

Question:

I have your E2RB0710 hitch with 8,000/800 bars and am wondering if you sell bars to raise my weight distribution capacity. Thank you.

asked by: Jesse C

0

Expert Reply:

Hey Jesse; it looks like that part number corresponds with the Fastway e2 Weight Distribution Hitch with round bars. You can upgrade your 800 lb bars with the Replacement Round Spring Bar for Fastway e2 Weight Distribution Systems - 1,000 lbs TW # FA94-02-1099. If you need anything else don't hesitate to reach out in the comments below.

expert reply by: Robin H

0

Replacement Round Spring Bar for Fastway e2 Weight Distribution Systems
(click to enlarge)

Jesse

4/3/2025

I just looked at the blue ox hitch and it looks just like my e2. Can you verify the blue ox 1200 lb bars will fit and I’ll get em ordered. Thanks again , Robin

Robin H.

4/3/2025

@Jesse unfortunately, these parts are not cross compatible. Many round bar systems look the same but the spring bars can't be interchanged. The Fastway round bars top out at 1,000 lbs so if you need something higher you will have to switch systems or switch to the trunnion style Fastway # FA92-00-1200.

Answer 1

It is possible to upgrade your Fastway e2 Round bar weight distribution system by using higher rated spring bars. I assume you have the 600 lb system, part #FA92-00-0600, so you can upgrade to a 800 lb tongue weight or 1,000 lb tongue weight system.…

view full answer...

Answer 2

All of the Replacement Round Spring Bars for the Fastway e2 Weight Distribution systems, #FA94-02-1099, #FA94-02-0899, and #FA94-02-0699, measure 31-1/2 inches long. The diameter of the bar at the upper end is 1.39 inches, and the inside groove…

view full answer...

Answer 3

Hey Justin! The only thing you need to purchase to upgrade the 600 lbs TW Fastway e2 Weight Distribution item #FA94-00-0600 are the 1,000 lbs TW Replacement Round Spring Bar for Fastway e2 Weight Distribution Systems item #FA94-02-1099. What kind of…

view full answer...

Answer 4

Hey Mike! We do have parts for your Fastway e2 round bar system. For spring bars you can choose from the following: -Replacement Round Spring Bar for Fastway e2 Weight Distribution Systems - 600 lbs TW #FA94-02-0699 -Replacement Round Spring Bar for…

view full answer...

Answer 5

Between round bar systems like #FA94-00-0600 and trunnion systems like #FA92-00-0600, I recommend going with a trunnion system because it will provide you better ground clearance than the round bar system. The trunnion bars come straight out from the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Replacement Spring Bars for Fastway e2 Round Bar WDH

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching