Can Yakima Round Crossbars be Added to 2013 Honda Civic

Question

Question:

I have old yakima roof rack system with round cross bars. The mounting attachments towers were for explorer with rail system that was flush to roof from factory. I want to use as much of these components as possible to mount to a 2013 honda civic with naked roof. What would I need?

asked by: Charles P

0

Expert Reply:

Hey Charles, so Yakima did change their roof rack setups a few years ago but there are still components that will allow you to use your current Yakima round bars on your 2013 Honda Civic.

You'd need the Baseline Towers part # Y28TR, two sets of # Y06125, and # Y03536.

expert reply by: Jameson C

0

Jameson C.

11/17/2025

Hey Charles, how did things go with the Baseline Towers and round bar adapters on your Civic’s naked roof? Your update could make it easier for the next person trying to reuse their older Yakima setup.

Answer 1

We do have a Single Yakima HD Crossbar #Y35FR which you can pair with the Two Towers #Y62TR. You will need the Adapters #Y03541 which we only carry as a set of 4 along with either the Front #Y06145 or Rear #Y06128 fit kit depending on if you plan on…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

Hey Kent! Your Alliance Avenue already has some great suspension components with the MORryde CRE3000 equalizers, wet bolt kit, and Rota-Flex pin box. I wouldn't replace any of those unless you're experiencing a specific problem. The next…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Can Yakima Round Crossbars be Added to 2013 Honda Civic

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching