Replacement Hub/Drum And Brake Assembly Components For A 2013 Cruiser RV Fun Finder X X-262BHS
Updated 02/03/2026 | Published 07/03/2024
Products Featured in This Question
Question:
I need to replace all four drums and brake hardware for my 2013 Fun Finder X262BHS. The drums it came with were Lippert 126003. What drums, shoes, and bearings will I need. Thanks, Rahn
asked by: Rahn R
Expert Reply:
Hey Rahn,
The Lippert 126003 hub assembly is the same as the Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 # AKHD-545-35-K and would use inner bearing # L68149, outer bearing # L44649, and grease seal # 58846. If you're wanting to just replace the shoes you can use part # AKBRKR-S-10 for manual-adjust assemblies or Right Hand # K71-682 and Left Hand # K71-681 for never-adjust/self-adjusting brake assemblies.
If you just want to swap out the whole brake assembly then you can go with part # AKEBRK-35-SA (self-adjusting) or # AKEBRK-35 (manual-adjusting).
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - LM11949
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- .75 Inch I.D.
- Bearing LM11949
- Race LM11910
- 3000 lbs Axle
- etrailer
more information >
Continue Researching
- Search Results: dexter brake pads
- Shop: Replacement Shoe and Lining Kit for Manual Adjusting 10" Electric Brake Assembly - 3,500 lbs
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Q&A: Will Replacement Brake Shoes For 10" Manual Adjust Electric Brakes Work With 3,500 lb Rockwell Axle
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Shop: Replacement Brake Shoes for Dexter 10" Nev-R-Adjust Electric Brake - Right Hand - 3,500 lbs
- Shop: Electric Trailer Brake Assembly - Self-Adjusting - 10" - Right Hand - 3,500 lbs
- Shop: Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Shop: Electric Trailer Brake Assembly - Self-Adjusting - 10" - Left Hand - 3,500 lbs
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Video: Measuring To Choose The Right Trailer Axle
- Search Results: trailer tires and wheels
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Video: etrailer VS Dexter Self Adjusting Brakes Comparison
- Article: How to Measure for Trailer Hitch Drop
- Search Results: trailer wiring
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Search Results: trailer jack
- Video: Review of etrailer Trailer Hubs and Drums - Hub with Drum - AKHD-545-35-EZ-K
- Shop: Brake Controller
- Q&A: What is the Best Grease for Trailer Bearings
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: etrailer Easy Grease Trailer Hub and Drums Installation - 2020 K-Z Sportsmen Classic Travel Trailer
- Search Results: trailer brakes
- Search Results: trailer hubs and drums
on Trailer Bearings Races Seals Caps
Robin H.
2/3/2026
Hey Rahn, how did the new hub and drum assemblies work out on your Fun Finder? Were the bearings and brake parts a good match for your setup? Your update could make it easier for the next person replacing their Lippert 126003 drums.