Dexter Nev-R-Adjust Electric Trailer Brakes Review Video

I sure can Bob and thanks for the information! Since you have a Lippert 3,500 lbs axle you'll be able to use the Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles item #AKHD-545-35-EZ-K, you were looking at. These have a 5 on 4-1/2 lug nut…

Hey Ken, the etrailer hub part #AKHD-655-35-K that you referenced uses TruRyde bearings. What brand do you prefer?

Hello Chris, thanks for reaching out. Based on my research, it looks like the AL-KO-7230 is a hub for a 3,500 lb axle with a 6 on 5-1/2" bolt pattern. We do offer a replacement for this, and for that I recommend the following: - Trailer Hub and…

Hey Craig, sorry about the confusion but the Trailer Hub and Drum Assembly #AKHD-655-35-K that you referenced does come pre-greased and ready to install. The bearings are in the hub, they have been packed with grease, and there's a grease seal…

Grease Seal #RG06-050 is the replacement part for the Dexter 010-019-00. It is 1.719 inches inner diameter and 2.565 inches outer diameter. It is a fit for 3500 lb axles. This is a confirmed replacement cross-reference.

The Replacement Race for 2585 Bearing item #2520 is made by Redline. The Replacement Trailer Hub Bearing - 2585 item #2585 is made by TruRyde.

TruRyde and Redline are the two brands of bearings that we carry. According to my contact at TruRyde they come with a limited 3 year warranty.

You're correct. A 6 on 5-1/2 inch bolt pattern will have 6 lugs with a 5-1/2 inch bolt circle. That means that if you measure from the center of one bolt across the hub to center of the opposite bolt, that distance will be 5-1/2 inches. I'll…

While brake assemblies have a distinct left and right hand side the hub/drums do not and can fit on either side of the trailer like with the part #84556UC3.

The Dexter Trailer Hub and Drum Assembly #8-174-5UC3 is a single hub and drum assembly. If you need a pair you will have to order a quantity of 2.

Hey Jared, If your axle has a brake flange like I have pictured below then you would be able to mount a 3,500lb brake assembly #AKEBRK-35 (manual-adjust) or #AKEBRK-35-SA (self-adjust). You'll also need to replace your idler hubs with drums so…

I'm not sure which brake adjustment tool you have but on our PT #W80630 there are two sides that can be used. The end with the 90 degree bend is designed for adjusting electric brakes on drop axles like yours, which will allow you to access that…