What Electric Trailer Jack Has Shorted Retracted Height

Question

Question:

My trailer rides very low and in order to not scrape and in order to get it low enough to store in the garage I need about a 5 inch retraction height. Has anyone seen an electric jack with a tongue that short? Please suggest electric jack with lowest retracted height please

asked by: BG

0

Expert Reply:

The electric jack we have that has the lowest retracted height is the Stromberg Carlson part # JET-3555 which has that dimension at 8-1/2 inches. Everything else is going to be 9 inches or more.

expert reply by: Jameson C

0

Answer 1

In order to power an electric trailer tongue jack using the 7-way trailer connector you would simply install a new trailer connector and attach the power wire from the jack to the battery charge line pin inside the trailer connector. If you go with…

view full answer...

Answer 2

Electric tongue jacks like the Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black #EJ-3520-BBX are designed to use a 12v power so if you want constant power I recommend using a trailer battery for connection. If you only want…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 9

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 10

Hello Theresa, Yes, the TorkLift GlowStep Revolution #TLA8002 will work on your 2022 Forest River Aurora 18BHS based on the measurements you provided. Your 24 inch ground clearance is right within the operating range for the 2-step #TLA8002, and the…

view full answer...

Answer 11

Hi Scott, thanks for reaching out. A great replacement for the 3,500-lb Lippert jack on your Jayco 32BHDS is the etrailer Electric Trailer Jack – A-Frame – 18" Lift – 3,500 lbs #e23ZV. It’s a bolt-on swap with the same capacity, upgraded…

view full answer...

Answer 12

Hi Mark; I'm sorry to say the mirrors for the F-150 will not fit your 2024 Ford Expedition. Since no custom towing mirrors are available, the best option is the K-Source Universal Towing Mirrors #KS3891-2. These have ratcheting straps to keep…

view full answer...

What Electric Trailer Jack Has Shorted Retracted Height

Product Page this Question was Asked From

Continue Researching