Search: electric tongue jack   >  

Yes, we do we just have it under a different part number. It is the MORryde X-Factor Crossmember for Standard Frame Hangers item #MR33WR. This is the crossmember that works with the CRE 3000 equalizer.

Yes, you can replace your weld-on coupler with a bolt-on coupler you will just have to drill the holes The Demco Cast Head Coupler w/ Jack Hole #DM37ZR would be a good replacement. The coupler has a 10,000 pound weight capacity and will fit a 2…

Unless you want to completely clean out every bit of grease you will need to stick to a LMX red grease like item #L11390 that comes with the CE Smith Trailer Idler Hub Assembly item #CE13515. You can use your blue marine grease but you…

To convert the WFCO WF-8955PEC to be lithium compatible you'd need the part #PD4655V and you'd be set. This fits in the panel without any modifications.

The Ultra-Fab Electric A-Frame Jack #UF38-944037 that you referenced would simply plug into the 7-way at the rear of your tow vehicle and would draw the power needed for the jack to work from the vehicle battery. Most all other tongue jacks are…

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just…

For your electric jack, there are only three possible explanations for your jack not working with a charged battery. Either power is not getting to your motor, your motor is bad, or your ground connection isn't working properly. To test…

Since your Grand Design came with the CRE3000 equalizers you will need three of the MORryde X-Factor Crossmember item #MR33WR. All of the hardware is included. I have linked an installation video below.

Thank you for the images. The MORryde Rubber Equalizers #MR87ZR are the correct set for your 2020 Keystone Outback Ultra-Lite 291UBH. You will pair this with the MORryde Suspension Upgrade Kit #MR46ZR. Instead of using the wet bolts included with…

Thank you so much for the purchases! To start, the answer to your first question is yes, all the bolts will indeed fit without any issue. Then as for additional bolts, there are no additional wet bolts needed or recommended to go along with the…

The easiest way to determine the correct replacement parts for your trailer's suspension is by simply measuring its existing components. Looking at one of your current equalizers, you will want to measure from the center of the front hole to…

The shackle strap length is measured from the center of one bolt hole to the center of the other. The Dexter Heavy Duty Suspension Upgrade Kit for Single Axle Trailers - Double Eye Springs #K71-358-00 uses 3-1/8" long shackles which are…