Recommended Replacement Trailer Jack for a Utility Trailer

Question

Question:

I am in need of a replacement trailer jack for an equipment trailer. It has a round post, manual jack now. The estimated weight of the trailer with equipment and fuel is about 17,500. What size jack would you recommend? Please provide the option of both manual and an electric jack.

asked by: Douglas

0

Expert Reply:

Douglas, you can use the Electric Jack w/ Footplate and 7-Way Plug # EJ-3527-BBX for an electric jack or the Buyers Products A-Frame Jack w/ Support Foot # 3370091265 for an manual option.

Both of these jacks would work great to replace the jack you currently have and would easily be able to handle your 17.5K trailer.

expert reply by: Bryce D

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 3

That's a great question, Neil! Yes, you can mount the etrailer Electric Trailer Jack #e23ZV facing to the side, similar to how your current Lippert jack is mounted. Manufacturers have gotten a lot better about this over the years, and the…

view full answer...

Answer 4

Hey Jess, welcome back, and good question. Short answer, no, it’s not stated as a .02 absolute rating, and that’s the key distinction. Blu Tech lists the AR3 as a 0.2 micron filter, but they also clearly note that those micron claims are “based on…

view full answer...

Answer 5

The Replacement MaxxFan Plus 4-Speed Roof Vent with White Lid #MA00-04751KSX is meant to be a direct replacement however not all the necessary hardware is included. The remaining items you'll need is the Key Wall Control part #MA00A03550K,…

view full answer...

Answer 6

I am not sure what your exact question is but the Lippert Power Gear Jack 181794 has been discontinued and there are no replacement parts available for this. Therefore, if you have an issue with yours then you will need to replace the entire jack and…

view full answer...

Answer 7

Hey Mark! All three of these etrailer jacks - the #e72QV 3,500 lb, the #e22QV 3,500 lb with SnapPad, and the #e82QV 5,000 lb with SnapPad - are powered directly through your truck’s 7-way plug. So with your Silverado’s factory 7-way, you can simply…

view full answer...

Answer 8

You reported that you cannot use the remote on your MaxxFan 4700K to put the vent cover up and down. Let's troubleshoot. Put some new batteries in your remote. Ensure that the display comes on. Verify if your vent cover now works. Verify if other…

view full answer...

Answer 9

The WVOM43 monitor you have now is the 1st generation system and, as you said, wireless. The #VCMS17B is a wired camera so it is not directly compatible. 1st generation parts are no longer being made, and the newer generation is not backwards…

view full answer...

Recommended Replacement Trailer Jack for a Utility Trailer

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching