Are There Replacement Plugs For Base Plates

Question

Question:

Can I buy plugs for my towbar when not in use lost at car wash

asked by: Laris H

0

Expert Reply:

Hi Laris; when you say tow bar were you referring to the base plates the tow bar fits into? If so then yes, there are replacement plugs for the base plates, it just depends on the manufacturer and style of the base plate you have. For example the Blue Ox fits all their base plates but the Demco is for their Tabless base plates only. I'll go ahead and list them out for you.

- Blue Ox Base Plates: Replacement Cap for Blue Ox Base Plates # BLU96XR

- Demco Tabless Base Plates: Replacement Cover for Demco RV Tabless Base Plate # DM15675

- Roadmaster EZ Base Plates With 1-1/2" Inner Diameter: Roadmaster EZ Base Plate 1-1/2" Receiver Covers # RM-210

- Roadmaster EZ Base Plates WIth 1-1/4" Inner Diameter: Roadmaster EZ2 Base Plate 1-1/4" Receiver Covers # RM-212

expert reply by: Kyle S

0

Answer 1

Hey Fred. The Roadmaster EZ2 Base Plate 1-1/4" Covers item #RM-212 will fit inside the receivers of the Blue Ox Base Plate Kit item #BX1126, however I don't know if they're going to stay secured while daily driving. The Replacement Tab…

view full answer...

Answer 2

Hey Geoffrey, We have a few different options that I'll list below, but if you can let me know what specific baseplate you have, I'll be able to let you know which on is the correct fit for you: - Demco Tabless Base Plates #DM15675 - Demco…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Are There Replacement Plugs For Base Plates

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching