Checking Out the LED Trailer Tail Light w/ Reflector Video

Great questions Jimmy, We haven't had any reports of the LED Trailer Tail Light w/ Reflector - Stop, Tail, Turn #DG52720PB having issues with hyper flashing so you should be good to go in those regards. When it comes to power draw, the tail light…

The LED Trailer Tail Light w/ Reflector #DG52721PB that you referenced is sold as an individual assembly. If you needed two of these you'd want to order a quantity of 2.

Looking at the lights for the 2011 Thor Freedom-Elite, we don't have a replacement lens that matches the design. The closest thing we have is a replacement light that features the 3-function lenses that looks very similar to yours. It's the…

The Command Electronics Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1 #CE44VR does not come with any instructions but the wiring diagram can be found on the rear of the lens housing if you pull back the foam…

If the roof on your enclosed cargo trailer isn't rounded too much then you actually don't need a pre-arched roof vent as you can see in the attached picture of the Ventadome #V2092SP-28 installed on an enclosed trailer. If your trailer is has…

Since your trailer uses a combined wiring system where the stop and turn signals run on the same circuit, in order to add a third brake light to your trailer you would need to use a 2-Wire to 3-Wire Converter, like part #118158. This will convert the…

If you want to go to the next size up from a 5.30-12 tire you will need to look at 13 inch wheels and tires ST175/80-13. For a wheel and tire combo with 5 on 4-1/2 bolt pattern and radial tire use #AM31985. This tire will be 7 inches wide and 24.1…

You have it right so far, the 4-way connector is just as you have stated. Remember that Yellow has a L in it so that is the left side brake/turn signal and green has a R in it so that is the right side brake/turn signal. The colors for wiring a 7-way…

I do have some replacement trailer axle options for you but in order to determine the correct replacement you'll need to measure the length which is done from the face of each hub. This when combined with the capacity can then be used to…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The closest thing we offer to Bargman 99 Incandescent Clearance Light #3499001 that you referenced that is an LED would be the Optronics Trailer Lights #MCL63RB. Dimensionally these lights are virtually identical. I attached a review video for this…

There is very little space at the back of trailer tail light #CE86FR but you should be able to get away with just one hole. It should be a nice tight fit. I have included a link to a video review of this light for you to view.