Availability Of Replacement Latch For Atwood 88555 2 Coupler  

I do have an option for you but Atwood was bought out and their replacement parts are no longer available, including the repair kit you would need. The best option is to replace that A-frame coupler with a new one that attaches to a 2 inch hitch…

To replace the Atwood 88555 coupler, I recommend Bulldog Heavy-Duty Cast Head Coupler w/ Wedge Latch part #BD43805W0317 which is a weld-on option rated for 8,000 lbs and takes a 2" ball.

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as…

I went out to our warehouse for you and measured the Tandem Axle Jeep Style Trailer Fenders part #HP62VR. The top part has a radius at each end so there isn't exactly a set point to measure from but I did my best to get the center of the…

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have…

So long as you took that eye to eye measurement with the weight off of the spring then yes the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles item #e44SR will indeed work for you. It is recommended to measure the springs with the weight of the…

The AT15775 part that you referenced was a replacement latch repair kit from Atwood for yoke style A-frame couplers. This kit is no longer available as Atwood was bought out and their parts were discontinued. For a replacement yoke style coupler for…

There will be no trailer coupler latch repair kit for an Atwood Trailer Coupler 88555 which is discontinued. Unfortunately, the only option is a full replacement for which I recommend the Demco A-Frame Trailer Coupler part #DM14793-81. This coupler…