Will Using 2 of the Timbren Axle-Less Trailer Suspension Kits Double the Capacity?

Question

Question:

Generally speaking, would two 2 3,500 LBS Timbren Axle-Less Trailer Suspension - Heavy Duty - Long Spindle - 4inch Lift - 5 Bolt - 3.5K equate to 7,000 LBS gross weight capacity, correct?

asked by: Bo D

0

Expert Reply:

Yes, you can use 2 of the Timbren Axle-Less Trailer Suspension Kits # ASR35HDS02 which will give you a total trailer GVWR of 7,000lbs. Do understand you must include the weight of the trailer into this calculation.

If you are needing to carry 7,000lbs above the weight of the trailer you will want 2 of the Timbren Axle-Less Trailer Suspension Systems # T99GR which each have a 5,200lb capacity.

expert reply by: Bud M

0

Answer 1

Hello Graham, thanks for reaching out. Both the parts you mentioned, the Timbren #T54KV and #TASR5200S03 are 5,200 lb axle-less systems. The difference is the #T54KV is designed for off-road applications with offroad tires while the #TASR5200S03 is…

view full answer...

Answer 2

Hey Fernando, so our best option would be the version of the same Timbren Axle Less kit but it was designed for off road tires part #T99GR. The max tire size this works with is 35x12.5-20 instead. Only other difference is that it has a 4 inch lift…

view full answer...

Answer 3

Hi Wesley! We actually have these listed slightly wrong, so I am having that updated. There is a difference and I have that listed below: Timbren Axle-Less Trailer Suspension System - 4" Lift Spindle - **Regular Tires** - 5,200 lbs #T54KV -We…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

The Dexter Nev-R-Adjust electric trailer brakes can be manually adjusted. There are a couple teeth of the adjustment wheel that are exposed just under the lever that you referenced. I have attached a photo showing the teeth. You will likely need a…

view full answer...

Answer 12

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Will Using 2 of the Timbren Axle-Less Trailer Suspension Kits Double the Capacity?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching