What Lighting Function Runs to Optronics Light Bar # MCL97RB
Published 12/12/2023
Question:
I have a question about a center marker light for a over 80 inch wide trailer I bought from you . It has dual function marker and center brake light. Where do I connect the brake light wire? To the trailer brake circuit or to one or the stop lights. If it is connected to a stop light wouldnt the center light also blink if signaling a turn with the light it is connected to? Do you have a wiring diagram for the center light for the brake light function?
asked by: Phillip
Expert Reply:
I found your order notes and it looks like you bought the Optronics light bar part # MCL97RB which is actually a single function light. It only would have the running light circuit ran to it.
Product Page this Question was Asked From
Identification Light Bar for Trailers over 80" Wide - Submersible - 9 LEDs - Silver Base - Red
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 14L x 1W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Lighting Requirements
- Q&A: Best Replacement Actuator for a Titan Aero-6000
- Q&A: What is the Difference Between Over 80 inch and Under 80 inch Trailer Tail Lights
- Q&A: Is Drilling Or Trimming Required To Install The EcoHitch EH72HR On A 2025 Hyundai Ioniq 5?
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Are the BP01-301 Brake Magnets the Same as BP01-330 Brake Magnets?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Ranger Trailer Cool Hub Replacement Grease Seal AD2527E
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Article: Trailer Maintenance Schedule
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)