bing tracking image
Q & A Icon

Replacement Tail Lights Recommendation for a 2005 EZ Loader Boat Trailer  

Updated 08/13/2024 | Published 06/23/2023

Question:

Good afternoon. Do you have a recommendation for replacement taillights r and l for a 2005 ez loader boat trailer. Over 80” wide, current lens states, SAE-AP2ST-DOT-01

0

Expert Reply:

Thanks for the photo, that really helps to narrow it down!

For incandescent replacements you need these Optronics Lights:

- Driver Side # ST57RS
- Passenger Side # ST56RS

Then for LED replacements you need these Optronics Lights:

- Driver Side # STL57RB
- Passenger Side # STL56RB

expert reply by:
0
Jon G
Tail Light on 2005 EZ Loader Boat Trailer
Tail Light on 2005 EZ Loader Boat Trailer
(click to enlarge)
Charlie T. profile picture

Charlie T.

7/17/2024

Can you recommend a wiring harness for these lights as well? Ideally, the lights and harness would have the 2 plug connections for east installation. I don’t really care if the lights are led or incandescent, I just want to replace the whole system so I know it will work. Thanks!

Jon G. profile picture

Jon G.

7/22/2024

@CharlieT These are only hardwired for the installation. Are your lights the same dimensions as the ones I referenced in the initial post? We could possibly get you setup with male and female pigtails but you would be splicing in to the tail lights as well as your trailer wiring for that.
Charlie T. profile picture

Charlie T.

8/12/2024

@JonG yes my lights are the same as the ones in the photos above. It’s also a 2005 ez loader. My lights and wiring have been through the wringer and I need a complete reset. What’s the easiest way to do that? I’d be fine with led or incandescent. Thanks
Jon G. profile picture

Jon G.

8/13/2024

@CharlieT I always recommend upgrading to LEDs whenever the opportunity arises which means you'll need the following: - Driver Side # STL57RB - Passenger Side # STL56RB The installation is pretty straightforward with the 2-bolt mounting and then you'll cut off your old wiring and connect the new wiring per function. If you use heat shrink butt connectors like the kit # DW05744-10 then it'll give those connections another layer of protection from water since they will be sealed when you shrink the tubing. Attached is an installation video of the lights so you can get an idea of what all it entails.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>